Steve83 > 1995 Ford F-150 > open folder Junker

What a beauty! All those used tires in the bed WERE in the cab a few minutes ago. Yes, the back wi...
Url
Tag
Img
Thumb
It was abused & neglected, and driven on 1 tank for a while. When that one died, it was abandoned f...
Url
Tag
Img
Thumb
2 tires off the rims; 2 dead gas tanks; 2 bent bumpers; 2 missing window cranks; 2 undamaged pieces ...
Url
Tag
Img
Thumb
Both doors will be replaced, the RHF fender, both bumpers, and the valance between the grille & bump...
Url
Tag
Img
Thumb
The bumper is pretty rough, but I'm gonna straighten it.
Url
Tag
Img
Thumb
A squirrell wintered under the seat - he's been getting in & out through the dislodged shifter cable...
Url
Tag
Img
Thumb
It looks like birds were roosting on the dash & crapping on the column due to the broken rear window...
Url
Tag
Img
Thumb
Safety Certification label in driver's door jamb above door latch strike (VIN edited) [url=https://...
Url
Tag
Img
Thumb
Calibration label in driver's door jamb
Url
Tag
Img
Thumb
EEC calibration code sticker in driver's door jamb Some trucks have this - others don't. Coincid...
Url
Tag
Img
Thumb
VECI Label under hood above master cylinder [url=https://www.supermotors.net/registry/media/858380]...
Url
Tag
Img
Thumb
4.9L FEAD belt routing sticker on core support
Url
Tag
Img
Thumb
Refrigerant label on core support
Url
Tag
Img
Thumb
Jacking Instructions sticker on core support [url=https://www.supermotors.net/registry/media/831119...
Url
Tag
Img
Thumb
Inertia Fuel Shutoff (IFS) switch sticker on core support
Url
Tag
Img
Thumb
The previous owner got as far as bending a tie-rod by hooking a tow chain there, connecting a fuel p...
Url
Tag
Img
Thumb
[url=https://www.supermotors.net/registry/media/825935][img]https://www.supermotors.net/getfile/8259...
Url
Tag
Img
Thumb
The #4 plug wire is off to see that it's sparking. [url=https://www.supermotors.net/registry/media/...
Url
Tag
Img
Thumb
95A 3G alternator. Note the 4 holes between each pair of front ribs, and that it's attached using t...
Url
Tag
Img
Thumb
Craptasmic battery, STONE-dead. Terminals destroyed. [url=https://www.supermotors.net/registry/274...
Url
Tag
Img
Thumb
The guy who had it before me used his 4WD tractor to drag it around his yard by the tie rod. [url=h...
Url
Tag
Img
Thumb
I didn't realize it was bent badly enough to dig the adjuster bolt into the sidewall, blowing out th...
Url
Tag
Img
Thumb
What a... [url=https://www.supermotors.net/registry/media/440042][img]https://www.supermotors.net/g...
Url
Tag
Img
Thumb
Amazing what you can do with a 12# sledge... Coincidentally, that same sledge was necessary to remo...
Url
Tag
Img
Thumb
With some creativity (plus 2 fire extinguishers, 2 gallon jugs of water, and a hose nearby), I creat...
Url
Tag
Img
Thumb
Temporary fuel system includes fire extinguishers, water jugs, & a garden hose. [url=https://www.su...
Url
Tag
Img
Thumb
I added a low fuel light, just to see how it went in a non-tach cluster. It was a little easier sin...
Url
Tag
Img
Thumb
To lift the bed, loosen the clamps (8mm, 5/16") around the filler supports, then slide them out...
Url
Tag
Img
Thumb
To lift the bed, remove the filler caps & filler neck screws (5.5mm, 7/32"), then push the neck...
Url
Tag
Img
Thumb
To lift the bed, disconnect the taillight wiring forward of the rear bumper. Go to the NEXT pic... ...
Url
Tag
Img
Thumb
To lift the bed, remove the nuts (18mm) for the bed bolts (8 on longbed; 6 on all others). Go to th...
Url
Tag
Img
Thumb
These bed bolts are in much better condition than I expected, considering how rusty the hubs were. ...
Url
Tag
Img
Thumb
To lift the bed for fuel tank access, I used my electric hoist (an ATV winch & some scrap metal). G...
Url
Tag
Img
Thumb
Easy! Go to the NEXT pic... [url=https://www.supermotors.net/registry/media/471464][img]https://ww...
Url
Tag
Img
Thumb
It'll be much easier to work on the tanks this way, rather than from below. Go to the NEXT pic...
Url
Tag
Img
Thumb
I'll vacuum & wash the tanks before opening anything. The unusually large fuel line fitting at the ...
Url
Tag
Img
Thumb
I'll vacuum & wash the tanks before opening anything. Go to the NEXT pic...
Url
Tag
Img
Thumb
Even though I put a safety strap under the suspended bed, I rolled the chassis out to work on the ta...
Url
Tag
Img
Thumb
After washing & vacuuming, and a little penetrating oil (NONE on the O-ring), the lock ring can come...
Url
Tag
Img
Thumb
Some force was necessary to break the FDM loose from the bottom of the tank. See the NEXT several p...
Url
Tag
Img
Thumb
I can't describe the smell... For more info, read these captions: [url=https://www.supermotors.net...
Url
Tag
Img
Thumb
The back tank was just as bad as the front. 6 years is too long for gas to sit. I burned both tank...
Url
Tag
Img
Thumb
After a few weeks' searching, I found a rear tank. It's from a '93, but the only difference is the ...
Url
Tag
Img
Thumb
Since I got the pigtail with the '93 tank, and I saved the original '95 pump plate, it was easy to m...
Url
Tag
Img
Thumb
To temporarily (or indefinitely) run any '90-96 dual-tank truck on 1 tank, it's necessary to plug bo...
Url
Tag
Img
Thumb
Today, I found a decent front tank & pump - only a little dent near the front.
Url
Tag
Img
Thumb
The motor spins, and I rebuilt the sender, which now produces a smooth signal. After it's installed...
Url
Tag
Img
Thumb
It works! For more info, read these captions: [url=https://www.supermotors.net/registry/2742/12737...
Url
Tag
Img
Thumb
Now that there are 2 working tanks, I can drop the bed back on. For more info, read these captions:...
Url
Tag
Img
Thumb
It's much cleaner than I expected.
Url
Tag
Img
Thumb
I think that rocker panel is the only damage to the cab.
Url
Tag
Img
Thumb
These rubber plugs are for the cab resonance weight. I haven't found any pattern to which trucks go...
Url
Tag
Img
Thumb
I've only had this for ~10 years - it's about time it got used on something. The "E3..." ...
Url
Tag
Img
Thumb
That's where it belongs... See the PREVious 2 pics.
Url
Tag
Img
Thumb
The first few blasts drained out nearly opaque brown - I think someone must have spilled a LOT of co...
Url
Tag
Img
Thumb
The seat cover, seatback, seat belts, & rear carpet got hosed out & sun-dried. The headrest covers ...
Url
Tag
Img
Thumb
The floor cover, floor-mounted belts, & rear carpet got hosed off, sun-dried, and treated with Lysol...
Url
Tag
Img
Thumb
I sanded & painted the shifter, and reinstalled the knob.
Url
Tag
Img
Thumb
The windshield side & lower trim were packed with leaves. While it was off, I removed the wiper val...
Url
Tag
Img
Thumb
It took a few hours with some BP hammers, prybars, & wood blocks, but it's pretty close to its origi...
Url
Tag
Img
Thumb
It almost looks like a truck again. The painter says he'll get to my doors, fender, & valance tomor...
Url
Tag
Img
Thumb
I've already straightened the reinforcing plate behind the headlight opening, but the core support i...
Url
Tag
Img
Thumb
I've only had a spare R fender for ~5 years, and it's almost the right color. [url=https://www.supe...
Url
Tag
Img
Thumb
It was probably the same squirrel who lived in the '93 Bronco who knew how to get in through the cow...
Url
Tag
Img
Thumb
This '93 Bronco door is MX (Dark Shadow Blue Metallic), which isn't quite as purple as this truck's ...
Url
Tag
Img
Thumb
Again: a big improvement. [url=https://www.supermotors.net/registry/media/850897][img]https://www.s...
Url
Tag
Img
Thumb
I picked up the painted parts yesterday, so I can finally remove the bad doors. Unfortunately, the ...
Url
Tag
Img
Thumb
About what you'd expect. The gasket has been smashed by the misaligned door for so long that it doe...
Url
Tag
Img
Thumb
I'd have gotten this fender on much faster if I hadn't had to change the voltage regulator, pull the...
Url
Tag
Img
Thumb
As usual, I'm painting at night. But it seems to be working OK - the other vehicles still look dece...
Url
Tag
Img
Thumb
Pretty good for spray painting in the dark on dirt with no prep. Now I just need some pinstriping.
Url
Tag
Img
Thumb
I wasn't planning to wash it for a week after I finished painting, but since a storm blew through la...
Url
Tag
Img
Thumb
Under all the sap, mildew, & grime, it's not as bad as I thought.
Url
Tag
Img
Thumb
I still have to touch up the tailgate, bed corner, & a few other spots, and paint on the pinstripes....
Url
Tag
Img
Thumb
I still have to touch up the tailgate & a few other spots, and paint on the pinstripes. But the bum...
Url
Tag
Img
Thumb
You'd never guess what it looked like 3 months ago, so here's a reminder: [url=https://www.supermot...
Url
Tag
Img
Thumb
I've never seen this before - it looks like someone went along the heater hose with a needle punchin...
Url
Tag
Img
Thumb
After a little driving, it became apparent that there was a serious oil leak dripping onto the rear ...
Url
Tag
Img
Thumb
This is after removing the throttle cover, the PCV & breather hose from their grommets, all the vacu...
Url
Tag
Img
Thumb
The main leak is the big GAP almost halfway down on the R side (LEFT in the pic) just this side of t...
Url
Tag
Img
Thumb
After a couple of long drives, I dumped & refilled the transmission, and cleaned the magnet. Fillin...
Url
Tag
Img
Thumb
It looks normal again, and I'm driving it whenever I can. [url=https://www.supermotors.net/registry...
Url
Tag
Img
Thumb
I rebuilt the MFS today, so everything is working now. [url=https://www.supermotors.net/registry/me...
Url
Tag
Img
Thumb
Clean enough to sit on, which is saying a lot, considering how bad it was. [url=https://www.supermo...
Url
Tag
Img
Thumb
The dash clunked every time I hit a bump, so I tracked down & installed one of the few remaining rep...
Url
Tag
Img
Thumb
This corner looks even better after some paint. [url=https://www.supermotors.net/registry/media/862...
Url
Tag
Img
Thumb
I found some black center caps in my junkpile which are correct, but rare. I'd rather put red ones ...
Url
Tag
Img
Thumb
I finally found another chrome rim for the RHR, and the bumper is a lot straighter than it used to b...
Url
Tag
Img
Thumb
I finally found another chrome rim for the RHR.
Url
Tag
Img
Thumb
The torn L engine mount is another part of the vibration during acceleration... [url=https://www.su...
Url
Tag
Img
Thumb
The torn L engine mount is another part of the vibration during acceleration... [url=https://www.su...
Url
Tag
Img
Thumb
The torn L engine mount is another part of the vibration during acceleration... I have the engine l...
Url
Tag
Img
Thumb
The torn R engine mount is YET another part of the vibration during acceleration... [url=https://ww...
Url
Tag
Img
Thumb
These were another part of the vibration during acceleration... It has been significantly reduced a...
Url
Tag
Img
Thumb
Frank bought it a month ago, and it's finally back for one more front fuel pump. For more info, rea...
Url
Tag
Img
Thumb
This 2WD Mazda M5OD-R2 output shaft gave no sign of damage before letting go while driving at very l...
Url
Tag
Img
Thumb
The ADM has been screeching intermittently, and it stunk. It has apparently been trying to burn its...
Url
Tag
Img
Thumb
Before & After
Url
Tag
Img
Thumb
  
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog