20190212_103907.jpg
276 hits | 113.22 KB | Posted: 2/14/19
After a decade, it's back at about 180Kmi. And it needs a lot of work...

The Bronco is still doing...

01Clean01.jpg
269 hits | 80.38 KB | Posted: 3/3/19
It had been parked for a few months on rural property, so job 1 was to remove the rat nests. I took...

01Clean04.jpg
210 hits | 81.42 KB | Posted: 3/3/19
It had been parked for a few months on rural property, so job 1 was to remove the rat nests. I took...

01Clean03.jpg
212 hits | 77.97 KB | Posted: 3/3/19
It had been parked for a few months on rural property, so job 1 was to remove the rat nests. I took...

01Clean06.jpg
210 hits | 63.36 KB | Posted: 3/3/19
The original floor pad was chewed & filthy, so I burned it, and replaced it with Peel & Seal (same a...

01Fin.jpg
239 hits | 90.08 KB | Posted: 3/3/19
Somehow, the fin for the driver's door seal rusted away, so I replaced it & sealed the hole in the f...

iOttieQiDash.jpg
292 hits | 88.35 KB | Posted: 3/3/19
I really like this charging cradle, but I hate that ...

01HeadlightsGrill.jpg
688 hits | 99.3 KB | Posted: 3/3/19
The original headlights have been foggy for years, and direct replacements are no better or more-dur...

01Mirror.jpg
347 hits | 35.05 KB | Posted: 3/9/19
The mirror & radio are re-recycled from the totalled '94 CV.

01Inverter.jpg
290 hits | 42.26 KB | Posted: 3/9/19
The 2KW inverter is wired to the battery positive via a 175A Mega fuse and two 8ga wires. It has 4 ...

01MyUSB.jpg
309 hits | 65.37 KB | Posted: 3/9/19
This dual USB jack has a 12V meter, and is wired to a key-switched circuit, which also powers 4 more...

01Overview.jpg
401 hits | 87.61 KB | Posted: 3/9/19
I moved the original PSOM into this tachometer cluster; I converted the oil pressure gauge to work; ...

ShKnob1.jpg
252 hits | 60.73 KB | Posted: 4/5/19
This cheapo shifter knob almost matches the exterior color, and cost a lot less than an OE knob woul...

CapTthr.jpg
660 hits | 83.13 KB | Posted: 4/5/19
Fuel Cap Tether grommets are all degraded by now, and I haven't found replacements for them. But I ...

20190424_092111.jpg
316 hits | 75.35 KB | Posted: 5/7/19
In preparation for hauling a ~440# spool of cable-distribution coax, I added some Explorer tiedowns ...

TGhingeserts.jpg
352 hits | 58.41 KB | Posted: 5/7/19
This kit was just over $6 shipped, and it's amazing ...

StepShield88407.jpg
372 hits | 94.95 KB | Posted: 5/7/19
I was hesitant to try "universal" parts when I know that fitted ones were once made; but t...

VentShades.jpg
317 hits | 75.55 KB | Posted: 5/12/19
Now I can vent the truck without letting rain in.

[url=https://www.amazon.com/dp/B0001EX6OM]AVS Ven...

EngMts.jpg
611 hits | 63.23 KB | Posted: 6/8/19
Fabricated engine mounts have been available for smallblock V8s for years, but not for 4.9Ls, which ...

SagSwap93.jpg
260 hits | 69.62 KB | Posted: 9/5/19
Saginaw PS Pump Swap

After finding a few Saginaw setups on a junkyard run, I cleaned up all their p...

SagSwap1.jpg
246 hits | 78.02 KB | Posted: 9/5/19
Saginaw PS Pump Swapped

After finding a few Saginaw setups on a junkyard run, I cleaned up all thei...

Receiver75038.jpg
171 hits | 65.44 KB | Posted: 3/4/20
I don't remember how this Draw-Tite 75038 ended up i...

01TailLEDs.jpg
182 hits | 87.35 KB | Posted: 3/30/20
These OLED license lamps will stay brighter longer.
...

TREboot.jpg
135 hits | 74.58 KB | Posted: 10/9/20
The boots are shot, but the tie rod ends are still tight & smooth, so I swapped on some [url=https:/...

BJnut.jpg
152 hits | 69.72 KB | Posted: 10/9/20
While doing some other work, I noticed the RHF wheel was VERY loose. It turns out the lower ball joi...

Arrived.jpg
131 hits | 117.21 KB | Posted: 3/2/21
I drove the F150 to buy a used F250 because I knew it would be easy to remove the front bumper & pul...