|
|
img_20200820_112033.jpg | Hits: 54 | Posted on: 8/20/20
| View Low-Res
20200820 - I started applying the new vinyl flooring I purchased from Bronco Graveyard (been sitting in the garage for over a year). The old beige carpeting was trashed. I kept the tailgate carpet, though, to match the trim around the sides and because the new flooring kit didn't come with a tailgate piece. Be aware of that if you buy from JBG. The gaps for the wheel wells in the bottom flooring are much bigger than the wheel wells. Hopefully the excess for the wheel wells will fill the gaps without looking too bad. Still gotta cut out the center where the rear seat locks in, and drill holes for the seat and seatbelt mounts. I used the heat gun to get the wrinkles out and, believe it or not, this looks way better than when I initially put it in. It's going to need a lot more massaging to get it flat before I start drilling and reinstalling things.
|
