dirty_TB.jpg
2062 hits | | Posted: 6/29/03
Dirty TB and inlet elbow
(Posted in: Headswap Pictures)

STA70616.JPG
2059 hits | 49.2 KB | Posted: 7/17/07
The woodgrain piece is held in with a few phillips head screws along the length of the trim.



The '95-'02 CV door trims are held on the same way, but are much shorter in length
(Posted in: Power 8-way passenger seat)

pdrm0145.jpg
2057 hits | 55.17 KB | Posted: 7/4/06
(Posted in: 1" Wheel Spacers and Air-lift air-springs (7/'06))

STA71555.JPG
2056 hits | 42.37 KB | Posted: 1/9/08
(Posted in: Custom dash bezel/surround)

1998_Mercury_Grand_Marquis_1024_x_768.jpg
2054 hits | 26.64 KB | Posted: 6/29/03
70.8 KB
(Posted in: Grand Marq Wallpaper)

scan.jpg
2054 hits | 43.38 KB | Posted: 4/5/06
95-97 GMQ 120 mph analog speedo
(Posted in: TECH/MISC -- Click for MISC tech pics-SEE SUBS)

STA72312.JPG
2053 hits | 73.05 KB | Posted: 5/31/09
(Posted in: Center Console & Floor Shifter Conversion (9/'05))

2003+cvgmqmmCORNERINGCONNECTORPINOUTc161.JPG
2053 hits | 31.52 KB | Posted: 1/29/08
2003-
CV/GMQ/MM cornering lamp connector
(Posted in: Panther LCM / lighting circuits and pinouts)

SS Marauder Tips.JPG
2049 hits | 58.53 KB | Posted: 4/18/04
Meg's SS Marauder Tips
(Posted in: Cat-back Exhaust)

03-04cvgmqdefrost.JPG
2049 hits | 42.67 KB | Posted: 2/7/10
2003-2004 CV/GMQ/MM Defrost
(Posted in: Panther Body/Chassis/MISC diagrams and pinouts)

BMW 745 2.jpg
2048 hits | 75.77 KB | Posted: 5/3/07
(Posted in: Crazy Accidents)

STA71556.JPG
2046 hits | 39.69 KB | Posted: 1/9/08
(Posted in: Custom dash bezel/surround)

pdrm0275.jpg
2045 hits | 44.21 KB | Posted: 8/9/06
From pass seat 1
(Posted in: A-Pillar VDO tach and pod install (8/'06))

Gauges Before.jpg
2045 hits | 38.38 KB | Posted: 4/9/08
After installing Autometer Ultra Lite II Volt and Oil Pressure gauges, I installed an Ultra Lite II Boost gauge to match. Plus, the shine-through LED lighting is far superior to the regular Ultra Lites.

Plus, I wanted to rearrange the order of th...
(Posted in: Boost Gauge)

Engine shot.jpg
2044 hits | 41.52 KB | Posted: 3/13/07
Got a 427 side oiler? Betcha don't.
(Posted in: Green GT-E Photos)

PC180023.JPG
2043 hits | 67.28 KB | Posted: 12/19/03
(Posted in: Megs Marauder Tips)

STA72314.JPG
2043 hits | 63.75 KB | Posted: 5/31/09
(Posted in: Center Console & Floor Shifter Conversion (9/'05))

9597corneringlamps.JPG
2041 hits | 44.8 KB | Posted: 3/27/07
95-97 cornering lamps
(Posted in: Panther LCM / lighting circuits and pinouts)

PDRM0283.JPG
2039 hits | 40.44 KB | Posted: 8/10/06
(Posted in: A-Pillar VDO tach and pod install (8/'06))

DSC_2848.JPG
2036 hits | 87.21 KB | Posted: 3/6/08
(Posted in: projector retrofit)

STA71377.JPG
2036 hits | 54.19 KB | Posted: 11/23/07
The Mustang cluster uses the external resistor. If I had the functional oil pressure switch, I would've jumped this resistor to make the gauge fulyl functional right then - but I'll do it later on
(Posted in: Mustang GT instrument cluster converson)

gmqBROCH (1).jpg
2035 hits | 45.31 KB | Posted: 10/16/06
1996 GMQ broschure spec scan
(Posted in: TECH/MISC -- Click for MISC tech pics-SEE SUBS)

1.jpg
2035 hits | 59.42 KB | Posted: 4/24/10
It had been months since the engine was last cleaned. Although the car was driven 0 miles within this time, as expected there was a heavy dust and dirt accumulation.


I didn't have all day to spend on it or anything, but it is easy to clean up.
(Posted in: Engine Bay)

hpim0045.jpg
2034 hits | 64.81 KB | Posted: 8/8/05
Front & Side Shot
(Posted in: 1996 Grand Marquis - See subfolders!! )

IMG_0048.jpg
2033 hits | 71.59 KB | Posted: 10/28/08
Cruzin colby-1
(Posted in: 1969 Mercury Marquis convertible.jpg)

71 Mercury Cyclone GT rear.jpg
2029 hits | 16.53 KB | Posted: 10/21/07
(Posted in: 1971 Mercury Cyclone GT)

69 Cyclone 1.jpg
2029 hits | 89.68 KB | Posted: 11/6/07
(Posted in: Kelly's 69 Cyclone)

STA70363.JPG
2028 hits | 67.75 KB | Posted: 5/28/07
(Posted in: EATC Conversion and big interior detail! 5/28/07)

STA72316.JPG
2024 hits | 55.02 KB | Posted: 5/31/09
(Posted in: Center Console & Floor Shifter Conversion (9/'05))

STA71378.JPG
2020 hits | 59.83 KB | Posted: 11/23/07
The anti-slosh. The unused trace is for a low fuel light. I may add a small yellow LED to serve as this.

In order to let the cluster fit, I had to use an anti-slosh from a 98-02 CV/GM cluster. The one in the stang cluster, and my Marquis' stock c...
(Posted in: Mustang GT instrument cluster converson)

03+headlamps.JPG
2017 hits | 22.32 KB | Posted: 10/10/07
03+ CV/GM/MM headlamp/autolamps
(Posted in: TECH/MISC -- Click for MISC tech pics-SEE SUBS)

marauderfoglamps.jpg
2015 hits | 52.45 KB | Posted: 1/29/08
2003-2004
Marauder foglamp wiring

06 GMQ w/ optional fog lamps similar
(Posted in: Panther LCM / lighting circuits and pinouts)

92TCantitheft.jpg
2015 hits | 38.26 KB | Posted: 5/17/10
(Posted in: Panther Body/Chassis/MISC diagrams and pinouts)

Sable5.jpg
2014 hits | 47.56 KB | Posted: 1/27/05
(Posted in: Interior)

ext-(19).jpg
2012 hits | 41.13 KB | Posted: 10/19/06
(Posted in: 1996 Grand Marquis - See subfolders!! )

sta70502.jpg
2011 hits | 16.63 KB | Posted: 8/8/07
new tip pic
(Posted in: 1996 Grand Marquis - See subfolders!! )

sta71339.jpg
2011 hits | 83.19 KB | Posted: 1/9/08
Basically, is just an air-compressor water/air separator with 1/4" NPT 3/8 hose barbs attached inline of the factory PCV.

I have it mounted on the valve cover (see pic)

Material I used:
~2ft fuel/oil 3/8" hose
1 1/4" NPT air-compressor inline...
(Posted in: PCV system oil catch (7/'06))

hpim0048.jpg
2008 hits | 56.57 KB | Posted: 8/8/05
Old pic, Marauder tips since removed in favor of factory style tips
(Posted in: 1996 Grand Marquis - See subfolders!! )

STA72329.JPG
2008 hits | 62.65 KB | Posted: 5/31/09
(Posted in: Center Console & Floor Shifter Conversion (9/'05))

STA72066.JPG
2005 hits | 74.34 KB | Posted: 5/26/08
(Posted in: Finished install)

sta70985.jpg
2003 hits | 43.7 KB | Posted: 9/17/07
(Posted in: September 07 quick detail)

Water pump and alternator removed_edit.JPG
2003 hits | 99.16 KB | Posted: 11/25/06
Step 9,10, and 11

Remove the alternator by removing the 2 10mm bolts underneith the alternator. Set alternator aside and leave the 2 bolts WITH the alternator.

Remove the water pump by first removing the 4 13mm bolts around the waterpump. then ...
(Posted in: PI INTAKE SWAP(HOT!!!!))

STA71037.JPG
2002 hits | 36.75 KB | Posted: 9/17/07
(Posted in: September 07 quick detail)

bodymount2.JPG
2000 hits | 10.06 KB | Posted: 1/15/07
body mount example
(Posted in: TECH/MISC -- Click for MISC tech pics-SEE SUBS)

STA70602.JPG
1998 hits | 64.62 KB | Posted: 7/17/07
Seat and track removed.


Very clean under there! :cool:

The wiring is the 8way power pre-wire
(Posted in: Power 8-way passenger seat)