IMG_0207.JPG 1408 hits | 80 KB | Posted: 11/27/05 And yet another (Posted in: Remote Transmission Filter)
IMG_0073.JPG 1407 hits | 70.88 KB | Posted: 8/6/05 I chose the passenger's side frame rail for the location for the remote trans filter. Using a cardboard template (cut from the Fram filter box) I sprayed the outline to know where to drill and tap the frame rail. (Posted in: Remote Transmission Filter)
Town Car Burnout.WMV 1398 hits | 1.84 MB | Posted: 10/10/03 (Burnout), doing some powerbraking in my Town Car. (Posted in: 2003)
IMG_0027.JPG 1398 hits | 50.23 KB | Posted: 3/10/06 One ball stud is bracketed onto the axle and the other is on the frame. They get dirty and rusty too. These are the studs the height sensor jumps off, disabling your compressor until the height sensor is stuck back on. (Posted in: Height sensor fix/repair)
IMG_0011.JPG 1375 hits | 55.83 KB | Posted: 3/10/06 This is the height sensor. One or both ends start to jump off the ball studs it attaches to. This tells the comprssor to go on strike and you're riding around arse down until you fix it. (Posted in: Height sensor fix/repair)
My Town Car VS. Crown Vic P73.WMV 1366 hits | 1.7 MB | Posted: 10/10/03 (Street Racing) My Town Car VS. 1997 Crown Victoria P73 (Posted in: 2003)
Town_Car_Movie.WMV 1362 hits | 1.87 MB | Posted: 6/30/03 Some spirited driving and drifting (Posted in: 2003)
IMAGE_123.jpg 1359 hits | 52.84 KB | Posted: 5/31/09 20x8.5 in front 20x9.5 in back Auto Couture Supreme 3 Piece (Posted in: PICS)
IMG_0080.JPG 1358 hits | 63.79 KB | Posted: 8/6/05 On my Lincoln the hot fluid comes from the trans to the higher fitting on the rad and returns via the lower rad line to the trans, somewhat cooler than before it's trip through the rad. (Posted in: Remote Transmission Filter)
Town_Car_Vs._Police_Car_Lumina_v6.mpg 1294 hits | 434.43 KB | Posted: 6/30/03 (Street Racing) 02' Town Car racing a police car (Lumina v6) (Posted in: 2003)
IMG_0541.JPG 1248 hits | 64.86 KB | Posted: 8/6/05 The block off plug(middle left) comes in case you you don't want to install the temp sender unit (from a $10 temp gauge). (Posted in: Remote Transmission Filter)
IMG_0020.JPG 1240 hits | 31.98 KB | Posted: 8/24/05 Just as well, look at the condition of the original stock part. (Posted in: Factory recall brass throttle cable bushing)
IMG_0106.JPG 1206 hits | 58.4 KB | Posted: 9/19/05 When the welds cooled down enough I cleaned them up with a wire brush. Then I nailed them with Plasticote's 1500 degree exhaust paint to postpone corrosion for a while. That stuff is dry in 6 minutes ! (Posted in: Y-pipe install day)
