Had to lower the front of the bronco so i made some new higher coilover mounts.. Used the bender this time and it came out pretty good..

Made the bumpstops out of some scrap 1/4"thick 1-1/2" diamter steel tube. Welded on a 1/4" thick disk and a bolt on the inside. Then just screwed on the bump stops.

Bump stops welded on, Coilover towers finished..

Brace connecting the coilover towers. Uses bushings from www.polyperformance.com to connect to the coilover towers. It can be removed if you need to mess with the engine.

finished shot..