|
|
Used 4"x8"x1/4" steel and cut them at about 15 degrees to relieve the stress on the bushing at ride height.
|
|
|
Welded a 3/16" thick plate to the top. It is then bolted and welded to the frame.
|
|
|
For the trac bar mount i used 2.5"x2.5"x1/4" steel
|
|
|
Chopped it up and welded it together.
|
|
|
This just shows the piece that will be welded to the mount and connect to the crossmember under the engine.
|
|
|
I cut the opening for the bushing and marked the hole for the bolt. Also welded a piece of 1/4" thick steel to one inside wall so that the bushing would fit snug.
|
|
|
Welded it to the frame and then welded the brace on (not visible)
|
SAS Stuff
