1995 Ford Bronco SAS Stuff pictures, videos, and sounds


Hits: 2059 Size: 53.18 KB Posted: 4/12/04 Used 4"x8"x1/4" steel and cut them at about 15 degrees to relieve the stress on the bushing at ride ...	Hits: 1755 Size: 48.4 KB Posted: 4/12/04 Shows the angle.	Hits: 1718 Size: 61.23 KB Posted: 4/12/04 Welded a 3/16" thick plate to the top. It is then bolted and welded to the frame.	Hits: 1613 Size: 61.46 KB Posted: 4/12/04 For the trac bar mount i used 2.5"x2.5"x1/4" steel	Hits: 1562 Size: 63.37 KB Posted: 4/12/04 Chopped it up and welded it together.
Hits: 1719 Size: 61.71 KB Posted: 4/12/04 This just shows the piece that will be welded to the mount and connect to the crossmember under the ...	Hits: 1727 Size: 56.23 KB Posted: 4/12/04 I cut the opening for the bushing and marked the hole for the bolt. Also welded a piece of 1/4" thic...	Hits: 1861 Size: 67.5 KB Posted: 4/12/04 Welded it to the frame and then welded the brace on (not visible)	Hits: 2877 Size: 52.83 KB Posted: 4/20/04	Hits: 2928 Size: 66.37 KB Posted: 4/20/04
Hits: 3160 Size: 68.21 KB Posted: 4/20/04	Hits: 3254 Size: 72.75 KB Posted: 4/20/04	Hits: 3219 Size: 67.05 KB Posted: 4/20/04	Hits: 3099 Size: 64.83 KB Posted: 4/20/04	Hits: 3276 Size: 67.41 KB Posted: 4/20/04