Damon Haas > 1994 Ford Bronco > open folder storage/shelf

I cut some 3/8 plywood to fit between the back of the front seats and little ledge in front of the b...
Url
Tag
Img
Thumb
i learned the hard way that the hing needs to be right on the edge to allow the shelf to fold up. I...
Url
Tag
Img
Thumb
top of the shelf carpeted. i had to clearance the shelf a little more on the drivers side.
Url
Tag
Img
Thumb
I took some time and made sure that the hinges, when mounted, would leave the shlef as level with th...
Url
Tag
Img
Thumb
this is the amount of gap I required, and it could actually be made a little larger or the joint mov...
Url
Tag
Img
Thumb
I made a deck, that will hold both amps (when I am done) on one side, and secured the shelf supports...
Url
Tag
Img
Thumb
the screws holding the support are barely noticeable with the carpeting
Url
Tag
Img
Thumb
should be enough clearance to keep the amps and inverter (once installed) cool.
Url
Tag
Img
Thumb
The shelf in, with the rear carpeting on top of the seam, instead of down the ledge, and the carpete...
Url
Tag
Img
Thumb
Full shelf without the sub. Should fake out would be's
Url
Tag
Img
Thumb
I was going to use this sub box, but its a little big, so i will have to find/make a smaller one.
Url
Tag
Img
Thumb
I was also going to cut section from the tape towards the back, and then use carpeted wood in its pl...
Url
Tag
Img
Thumb
I welded some angle iron on to my swing away to mount some axleshafts etc.
Url
Tag
Img
Thumb
these are mounts I sourced through work. Lots of fire depts use these to mount assorted tools.
Url
Tag
Img
Thumb
They can hold axle shafts, my 8 pound sledge, and hi lifts with ease. Im assured that sun and weat...
Url
Tag
Img
Thumb
Here is how my tire carrier looks. the old 5 on 5.5 tire carrier has been changed to 8 on 6.5, and ...
Url
Tag
Img
Thumb
Url
Tag
Img
Thumb
Url
Tag
Img
Thumb
  
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog