bottom seat cushion removed

back seat cushion removed

remove snaps to reveal the bolts (i used a flat-head screwdriver) and unbolt (12mm)

Tricky part: separate the rear deck lid from these two clips in the side panels. I used 2 screwdrivers to pry them out. Takes a while, but isn't super hard

close up

Don't forget to disconnect the third brake light

close up

removed rear deck lid

remove the matt by unsnapping the 4 plastic snaps

another close up of the tabs you have to get past to remove the deck lid

my supplies. $30 from Lowes

made sure to wrap this thing up heavy, as it seemed to be a good spot for vibrations

around 1/3 of a roll left after doing the rear deck and a few spots twice

starting on the back panel

removed this piece...im not even sure what it is... to peel & seal behind it

another angle

after 1 full roll of Peel & Seal

the aluminum foil on the back of the Peel & Seal did this...

Star of roll #2 and stopping point for day #1

also did my gas lid, solid as a rock

starting to put it all back in

little bit of deadener on the trunk lid

end of roll #2

Finished rear of the car

Finished rear