Dust boot off of an 80's GT Mustang. Should help keep some water out of the distributor during water crossings.

Reinforced shackles, courtesy of Keith Lawyer, from FullsizeBronco.com. I think you need shackle bushing part #4-2144 as seen here:
http://www.suspension.com/fordtruck3.htm

The legs are plated with 1/8" and the cross section is plated with 3/16" lowered to reduce the lever arm of the legs. The spring eye still fits with no
interference.

Idea for cargo area design, what I think I am going to do is cut a piece of plywood to fit just beneath the cab, then reinforce the bottom side with one by and covering the type with some sort of rubber pad. Still working out some details.

Cheap intake modification, courtesy of Dustin from FSB. Remove factory air box and all the crap associated with it, replace with K&N Filter P/N RF-1012 mount to fender.

Cargo area design courtesy of Chris Campbell.

Shackles after I painted them, they look pretty good now.

Stock fan clutch on the left, severe duty fan clutch on the right.

Added a cable stay for the tire carrier. Helps if I forget to re-latch the carrier before I drive away.