Jeremy Millrood > 1992 Ford Bronco > open folder Powersteering Gearbox Rebuild

To make it easier to work on remove the airinlet tube from the air box, and set it aside. If you can...
Url
Tag
Img
Thumb
These three bolts must be removed for the powersteering box to come off of the frame.
Url
Tag
Img
Thumb
When removing the steering shaft from the sector shaft, it helps to have to sets of hands. The bolt ...
Url
Tag
Img
Thumb
Removing the return lines was a little difficult, this probably took the most time, mine had never b...
Url
Tag
Img
Thumb
Getting ready to remove the pitman arm with a puller, you definitely want to use a puller.
Url
Tag
Img
Thumb
Pitman arm about to come off.
Url
Tag
Img
Thumb
Pitman arm finally removed.
Url
Tag
Img
Thumb
Once the pitman arm is removed, you can completely remove the box from your rig. There are 3 bolts g...
Url
Tag
Img
Thumb
Snap ring over the trashed seal. It helps to have a good set of ring pliers.
Url
Tag
Img
Thumb
Sector shaft removed completely from the box. There was a little scoring around the shaft from wear ...
Url
Tag
Img
Thumb
After sanding the sector shaft for about 15 minutes, I used a light grade sand paper to take the sco...
Url
Tag
Img
Thumb
Installing the new seal. Find an appropriate sized socket so you can hammer the new seal in. You wan...
Url
Tag
Img
Thumb
The new snap ring will go right on once the seal has been seated properly. Once this is done give th...
Url
Tag
Img
Thumb
Here is my resealed box, looks almost like new. Installation is the reverse of the removal. You may ...
Url
Tag
Img
Thumb
 
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog