Jeremy Millrood > 1992 Ford Bronco > open folder U-joint replacement

Taking the c-clips out was a little difficult, I was able to get this one out with a pick, but the o...
Url
Tag
Img
Thumb
Using the balljoint press to push the caps out, these were in pretty tight so it took a little effor...
Url
Tag
Img
Thumb
This is what it will look like once the cap has been pushed out.
Url
Tag
Img
Thumb
Make sure you push the opposite side of the u-joint out after you get one of the caps off.
Url
Tag
Img
Thumb
Url
Tag
Img
Thumb
Url
Tag
Img
Thumb
Here are the caps after they had all been pushed off. One of the caps actually popped.
Url
Tag
Img
Thumb
All of the caps have been pushed off. Now I can't get the u-joint out of the inner axle shaft. I tri...
Url
Tag
Img
Thumb
Took a 5 pound sledge hammer, placed the base of the ears on a block of wood, and hit the u-joint.
Url
Tag
Img
Thumb
It came right out after 2 hits.
Url
Tag
Img
Thumb
These are the u-joints I used for the front axles, Brute Force, part # 10297BF.
Url
Tag
Img
Thumb
This is the u-joint, the end caps pull right off. Be careful with them, as you don't want to mess up...
Url
Tag
Img
Thumb
After removing the caps, I positioned the u-joint betweent the two axle pieces. You may have to work...
Url
Tag
Img
Thumb
Here is another angle of the u-joint seated. The caps have not been installed yet.
Url
Tag
Img
Thumb
Here I am about to push one of the caps on, they actually slid on pretty easily. Make sure you do th...
Url
Tag
Img
Thumb
Pressing the cap on with a balljoint press, this is a great tool. I highly recommend spending the $1...
Url
Tag
Img
Thumb
Here is the axle completely assembled with the new u-joint installed. Now the tricky part is install...
Url
Tag
Img
Thumb
   
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog