Roll bar I found in a 1991 Bronco. What a pain it was to get it out, but it was worth it.

Finished painting the roll bar, ready to install it.

Another shot of the roll bar after I finished painting i.

Test fitting the roll bar, I had to move some of the wiring harness that went across the floor.

Another shot of the test fitting I had to cut off the rear bolt for the seat belt mount to get it to mount where I wanted it. The grinder made short work of the bolt.

It's all bolted in, I used 1/2 inch, 1 inch and a half coarse thread grade 8 bolts with regular and lock washers. I'm going to reinforce the back side with the additional plates.