michael collins > 1983 Ford Bronco > open folder Clutch

After the body lift i was forced a question. What to do with the mechanical clutch system.i was goin...
Url
Tag
Img
Thumb
here is another angle. you can see the pivet end is junk.
Url
Tag
Img
Thumb
The rod is almost 1/2 thick.
Url
Tag
Img
Thumb
the leagth is 23" so i need one 3" longer to off set the body lift and i added 1/2 for the taller bo...
Url
Tag
Img
Thumb
The equlizer rod (Below the linkage) the rectangle hole rounds out and causes slop in the shifter an...
Url
Tag
Img
Thumb
I looked at the sprint car circuit and got a custom made rod and heim joints.
Url
Tag
Img
Thumb
Here is a closeup of how it was going to connect the equlizer. bar
Url
Tag
Img
Thumb
Here is all the rod parts and the bellcrank. i found the plastic bushings were broken and had to got...
Url
Tag
Img
Thumb
Here is the bell crank all rebuilt and ready to go back in the truck.
Url
Tag
Img
Thumb
Here is the bell crank end of the clutch rod.
Url
Tag
Img
Thumb
Here is the rod all painted and ready to reinstall.
Url
Tag
Img
Thumb
Here is the bell crank back in the bronco.
Url
Tag
Img
Thumb
Here is the connection to the throw out arm.
Url
Tag
Img
Thumb
here is a shot of the rod going up to the equlizer bar. it is here i found another issue. the hole t...
Url
Tag
Img
Thumb
Not the cleanest hole but it will work for now.
Url
Tag
Img
Thumb
Here is the top end of the hole in the floor.
Url
Tag
Img
Thumb
Here is the connection to the equlizer bar. This setup works great.
Url
Tag
Img
Thumb
   
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog