michael collins > 1983 Ford Bronco > open folder NP 208

After the body lift i eather had to cut the floor of redisign the shifter. i did not like the locati...
Url
Tag
Img
Thumb
This was round 1 with the shifter. I cut and added a 3" spacer.
Url
Tag
Img
Thumb
a coat of paint and it was looking good.
Url
Tag
Img
Thumb
Here it is all installed and working fine.
Url
Tag
Img
Thumb
Here is another shot. i was proud of the way it turned out.
Url
Tag
Img
Thumb
Well i was showing a friend how good a job i did and i grabbed the transfere case shifter and off it...
Url
Tag
Img
Thumb
I got a new stronger rear drive shaft and this new shaft required a flang to install it not the yoke...
Url
Tag
Img
Thumb
here is the side view of the yoke.
Url
Tag
Img
Thumb
here is the side view. i wanted to get the size so i could get the correct u joints.
Url
Tag
Img
Thumb
Here is the output shaft size.
Url
Tag
Img
Thumb
The cv joint gets bolted to this to the transferecase.
Url
Tag
Img
Thumb
this is the rear output shaft. i got a new seal and replaced it at this time.
Url
Tag
Img
Thumb
here is a different view of the case. man is it dirty.
Url
Tag
Img
Thumb
Here is the new flang ready to get installed.
Url
Tag
Img
Thumb
Here is the output shaft for the NP208. it is 32 spline shaft. this was just after i removed the yok...
Url
Tag
Img
Thumb
They redesigned the seal. here is the old (left) and the new seal (right)
Url
Tag
Img
Thumb
Here is the new seal at its new home.
Url
Tag
Img
Thumb
here is the new flang in its new location. this was an easy swap.
Url
Tag
Img
Thumb
Here is the flang all tourqued down and ready for the new drive shaft.
Url
Tag
Img
Thumb
 
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog