When i got this beast on the road i found there were no running lights in the running light switch posisition. if i turned it to headlights they came on, but if i hit high beam the running lights went off. so i pulled the light covers to take a look. I found this on the pass side. the PO added a second lightbulb for running lights. the socket was flaoting in the brake light housing and the wires pinched and had a few shorts.

the PO ran wire from the pass side tail light to the drivers side tail light (same temp light socket in the lens deal and then under the bronco to the lowbeam headlight.

here it all clean and ready to go back together.

Here is the driver side head light where they tapped into to get power for the running lights.

here is the drivers side it was full of bad connections. so i replaced the sockets.

here it is all gutted.

here is another shot

i got a better shape harness from the junk yard.

The tail light lens covers are in poor shape so i thought i see if the plastic polish i have would make them better.

i found the whole issue was a bad switch. i replaced it and now i got running lights and head lights again.

here it is installed and working fine

here it the back end all together.