After removing all the bolts but 2 (tey were broken) i was able to slide the topp off.

this was the broken driverside bolt. i had to cut it off and gring it flat. i then drilled and tapped a new hole.

here is the broken pass side bolt. I cut the clip and tossed this bolt and clip.

here was the rear bolt. it is a flat slice of steel in a pocket. i could not remove it so i tapped a new 8mm hole.

i was missing the pins that help align the top. i got a few from the junk yard.

here the oin is in the hole. all this pin does is align the top so it does no slide off the truck.

the top is not too heavy- it is bulky and 1 person can pull it but 2 make it real nice. here it is on the grass at this time.

the rear glass is in the tailgate so the only glass is the side windows.

you can see the glass goes down in the gate.Tip do not roll up and drive without the frame support the glass will break.

here she is topless

topless another shot

drivers rear topless

here she is from the front door topless.

here is the pass side before the tint.

well the tinting was real bad so i removed it. here is the pass side.

here is the drivers side with the old tint on.

here is the drivers side.