1983 Ford Bronco Pivot Bushings pictures, videos, and sounds


Hits: 1251 Size: 96.15 KB Posted: 11/9/06 Here is the stock pivet mount bushing (i was replacing the TTB drop mount so it is not in the pictur...	Hits: 1132 Size: 66.87 KB Posted: 11/9/06 Here was the old pivet mount. they tack welded it in place.	Hits: 1035 Size: 67.16 KB Posted: 10/27/06 the old mounts do not come out too easy. i used the drill many holes in the rubber and then an air c...	Hits: 1452 Size: 103.68 KB Posted: 11/1/06 I did the bushings on the bronco. i put the jack stand on the outer axle and used the floor jack as ...	Hits: 1235 Size: 70.39 KB Posted: 10/27/06 Here is the tool you will want to get if you are installing new bushings. i could have used this to ...
Hits: 1295 Size: 102.66 KB Posted: 11/9/06 This is after i drilled out the rubber and used the air hammer to punch out the shell.	Hits: 1228 Size: 65.05 KB Posted: 10/27/06 Here is the new bushing installed and ready to go in the new mount.	Hits: 1674 Size: 81.56 KB Posted: 11/1/06 Here is a close up of the new bushing.