michael collins > 1983 Ford Bronco > open folder Wiring Harness conversion

This is the stoce fuel tank and guage harness. The donor had 2 fuel tanks. i going to remove the not...
Hits: 705
Size: 65.73 KB
Posted: 1/16/07
This is the stoce fuel tank and guage harness. The donor had 2 fuel tanks. i going to remove the not...		this is the fuel tank connection and the rear anti lock brake sendsor (VSS)
Hits: 463
Size: 56.3 KB
Posted: 1/16/07
this is the fuel tank connection and the rear anti lock brake sendsor (VSS)		this is the front part of the harness. the main plug, anti lock valve plug, wiper,
Hits: 435
Size: 61.62 KB
Posted: 1/16/07
this is the front part of the harness. the main plug, anti lock valve plug, wiper,		this is the anti lock brake valve plug. (not needed)
Hits: 479
Size: 58.32 KB
Posted: 1/16/07
this is the anti lock brake valve plug. (not needed)		this is the firewall plug and anti lock plug
Hits: 485
Size: 52.03 KB
Posted: 1/16/07
this is the firewall plug and anti lock plug
anti lock valve
Hits: 456
Size: 52.52 KB
Posted: 1/16/07
anti lock valve		anti lock valve 2
Hits: 431
Size: 56.01 KB
Posted: 1/16/07
anti lock valve 2		here is the rear anti lock sensor or tone ring counter.
Hits: 450
Size: 47.41 KB
Posted: 1/16/07
here is the rear anti lock sensor or tone ring counter.		This is the fuel ground tap.
Hits: 560
Size: 48.03 KB
Posted: 1/16/07
This is the fuel ground tap.		this is the different plugs labled
Hits: 476
Size: 46.77 KB
Posted: 1/16/07
this is the different plugs labled
the fire wall plug
Hits: 487
Size: 43.37 KB
Posted: 1/16/07
the fire wall plug		i was missing the TFI remote connector and module. I got this at the local junk yard.
Hits: 635
Size: 34.18 KB
Posted: 1/16/07
i was missing the TFI remote connector and module. I got this at the local junk yard.		here is the back of the module. it screws to the drivers side fender
Hits: 458
Size: 35.25 KB
Posted: 1/16/07
here is the back of the module. it screws to the drivers side fender		this is the wiper/ cruse control end of the motor harness.
Hits: 493
Size: 37.3 KB
Posted: 2/2/07
this is the wiper/ cruse control end of the motor harness.		here is the harness all split out. lots of fun tracking wires.
Hits: 448
Size: 54.71 KB
Posted: 2/2/07
here is the harness all split out. lots of fun tracking wires.
this end goes to the motor and all its sensors. i not pulled anything from it so i wrapped it backup...
Hits: 583
Size: 44.54 KB
Posted: 2/2/07
this end goes to the motor and all its sensors. i not pulled anything from it so i wrapped it backup...		here is another view of all the mess.
Hits: 719
Size: 54.39 KB
Posted: 2/2/07
here is another view of all the mess.		Here is the under the hood or motor harness ready to be installed. I still going to get the sprial c...
Hits: 485
Size: 40.39 KB
Posted: 2/2/07
Here is the under the hood or motor harness ready to be installed. I still going to get the sprial c...		this is much cleaner and ready to be installed.
Hits: 657
Size: 39.8 KB
Posted: 2/2/07
this is much cleaner and ready to be installed.		this wires goto the front of the engine compartment.
Hits: 509
Size: 38.72 KB
Posted: 2/2/07
this wires goto the front of the engine compartment.
i am going to use the stock ford relay/aux fuse box.
Hits: 623
Size: 57.95 KB
Posted: 2/2/07
i am going to use the stock ford relay/aux fuse box. 		now for the under the dash wiring.
Hits: 498
Size: 50.97 KB
Posted: 2/2/07
now for the under the dash wiring.		This is the plug side of the wiring
Hits: 501
Size: 61.57 KB
Posted: 2/2/07
This is the plug side of the wiring		this side is the heater and radio and center cluster wiring. most not going to be used.
Hits: 455
Size: 61.72 KB
Posted: 2/2/07
this side is the heater and radio and center cluster wiring. most not going to be used.		i had these plug holes on one plate but i could not get it to fit anyway, so i made 2 panels and riv...
Hits: 495
Size: 54.4 KB
Posted: 3/12/07
i had these plug holes on one plate but i could not get it to fit anyway, so i made 2 panels and riv...
you can see right thru to the engine compartment.
Hits: 582
Size: 44.46 KB
Posted: 3/12/07
you can see right thru to the engine compartment.		this is the motor side of the conversion. I going to flatten the rivets i then paint the area and i...
Hits: 584
Size: 52.42 KB
Posted: 3/12/07
this is the motor side of the conversion. I going to flatten the rivets i then paint the area and i...		this is the fuel tank wiring harness. it is now connected to the under dash harness.
Hits: 529
Size: 83.4 KB
Posted: 10/12/07
this is the fuel tank wiring harness. it is now connected to the under dash harness.		i routed it along the same path and the stock wire harness.
Hits: 466
Size: 81.12 KB
Posted: 10/12/07
i routed it along the same path and the stock wire harness.		i got the stock efi fuel filter instaled in the stock location
Hits: 477
Size: 38.06 KB
Posted: 10/12/07
i got the stock efi fuel filter instaled in the stock location
you can see the fuel pressure and return line and the wire harness for the tank
Hits: 489
Size: 39.74 KB
Posted: 10/12/07
you can see the fuel pressure and return line and the wire harness for the tank		here it is connected o the fuel tank
Hits: 537
Size: 55.16 KB
Posted: 10/12/07
here it is connected o the fuel tank		now the computer and the other connector are connected
Hits: 491
Size: 81.12 KB
Posted: 10/12/07
now the computer and the other connector are connected		i going to use the stock 1992 aux relay/fuse panel box. here is the stock mount
Hits: 498
Size: 64.83 KB
Posted: 10/12/07
i going to use the stock 1992 aux relay/fuse panel box. here is the stock mount		here is is bolted to the fender. i had to drill 3 holes and then nut it from the bottom.
Hits: 492
Size: 59.66 KB
Posted: 10/12/07
here is is bolted to the fender. i had to drill 3 holes and then nut it from the bottom.
i did not want alot of different connectors for an ignition hot power. i used this power take off fr...
Hits: 487
Size: 55.66 KB
Posted: 10/12/07
i did not want alot of different connectors for an ignition hot power. i used this power take off fr...		Here is the mid ignition switch on the column. this is the stock wiring switch and plug.
Hits: 469
Size: 40.21 KB
Posted: 6/10/08
Here is the mid ignition switch on the column. this is the stock wiring switch and plug.		a closer view of the switch and wire colors. this switch is the acc/ignition and off switch.
Hits: 440
Size: 47.71 KB
Posted: 6/10/08
a closer view of the switch and wire colors. this switch is the acc/ignition and off switch.		this is the whole switch for a 1992 early mid column switch.
Hits: 456
Size: 45.51 KB
Posted: 6/10/08
this is the whole switch for a 1992 early mid column switch.		this is to see the part number on the switch. i will not be using it.
Hits: 496
Size: 53.91 KB
Posted: 6/10/08
this is to see the part number on the switch. i will not be using it.
i found the under the hood panel box was wrongly installed so i corrected it.
Hits: 488
Size: 49.81 KB
Posted: 6/10/08
i found the under the hood panel box was wrongly installed so i corrected it.		    
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog