|
|
 Hits: 708 Size: 47.42 KB Posted: 2/16/07 here is the new skid plate. i got it withthe efi tank. |  Hits: 596 Size: 53.9 KB Posted: 2/16/07 this is a 33 gallon 3 1/2" top tank. this has the single high pressure pump and sending unit inside. |  Hits: 492 Size: 65.21 KB Posted: 2/16/07 here is the other side. time to clean and install it. |  Hits: 636 Size: 66.76 KB Posted: 3/1/07 here is the tank after it was cleaned and undercoated on the bottom. there is a coat of flat black o... |  Hits: 604 Size: 76.08 KB Posted: 3/1/07 hereis another view of the bottom of the tank almost ready to go in. |
 Hits: 608 Size: 64.85 KB Posted: 3/1/07 here is the last shot of the bottom untill it gets installed. |  Hits: 545 Size: 49.47 KB Posted: 3/5/07 i decided to make sure the inside was good and clean. here is the inside before i cleaned it out. no... |  Hits: 456 Size: 52.97 KB Posted: 3/5/07 here is the pass side inside the tank. |  Hits: 453 Size: 49.28 KB Posted: 3/5/07 inside tank drivers side. |  Hits: 426 Size: 31.2 KB Posted: 3/6/07 after disconnecting the fuel line, filler neck, vent line and the sending unit wires i emptied the g... |
 Hits: 579 Size: 69.44 KB Posted: 3/5/07 i washed the area where the tank was. i then hit it with flat black. |  Hits: 455 Size: 63.33 KB Posted: 3/5/07 here is another shot of no tank. |  Hits: 561 Size: 44.82 KB Posted: 3/6/07 these are the old fuel lines. i going to pull them out and swap in the new EFI lines soon. |  Hits: 463 Size: 67.47 KB Posted: 3/6/07 this is the hole where the fuel tank was. i need to clean it up and hit it with some paint. |  Hits: 462 Size: 39.61 KB Posted: 3/6/07 here is the top straps that sandwhich the tank into its place. |
 Hits: 480 Size: 49.75 KB Posted: 3/6/07 this is the pass side vent line to the charcole can under the hood. i going to swap it out for the n... |  Hits: 604 Size: 72.99 KB Posted: 3/6/07 here is the old tank and skid. |  Hits: 542 Size: 74.01 KB Posted: 3/6/07 here is another view of the tank and skid plate. |  Hits: 480 Size: 73.34 KB Posted: 3/6/07 here is the last shot of the old tank and skid plate. |  Hits: 469 Size: 48.52 KB Posted: 7/3/07 here is the stock 83 carb fuel tank. |
 Hits: 539 Size: 57.58 KB Posted: 7/3/07 this view shows the small neck and sending unit holes of the non-EFI fuel tank. |  Hits: 544 Size: 62.41 KB Posted: 3/5/07 i wanted to have a way to get the dirt out from under the tank. i had this chunk of bed liner on the... |  Hits: 554 Size: 58.2 KB Posted: 3/5/07 now it is all going back together, i put 2 bolts on the back side of the gas tank to hold the skid p... |  Hits: 649 Size: 58.1 KB Posted: 3/5/07 i put the bed liner on the bottom of the skid plate.. |  Hits: 730 Size: 57.78 KB Posted: 3/5/07 i then put the gas tank in the skid plate on the bed liner. |
 Hits: 547 Size: 69.82 KB Posted: 3/5/07 i forgot the top straps were adjustable so i got longer bolts first. i will trim them down some soon... |  Hits: 492 Size: 44.65 KB Posted: 3/5/07 here is the pass side bottom of the tank and skid. |  Hits: 617 Size: 40.47 KB Posted: 3/5/07 here is the pass side tank top. |  Hits: 570 Size: 52.09 KB Posted: 3/5/07 here s the drivers side tank bottom. |  Hits: 569 Size: 56.7 KB Posted: 3/5/07 here is where the filler neck goes.. |
 Hits: 428 Size: 46.25 KB Posted: 3/5/07 you can see the fuel line connection point. i got to run the lines and power next. i stll got to rem... |  Hits: 497 Size: 52.05 KB Posted: 3/9/07 the filler neck was next since the newer version has a screw in cap not twist on. and there is a fil... |  Hits: 498 Size: 54.2 KB Posted: 3/9/07 here is another shot of the filler hose. |  Hits: 569 Size: 39.79 KB Posted: 3/9/07 here is the new filler neck. some how i broke the screw in cap , so i get a new one soon. |  Hits: 414 Size: 53.31 KB Posted: 7/3/07 the EFI uses a larger 3/8 Evap line. here is the 1/8" line in the stock location. it runs in 2 piece... |
 Hits: 421 Size: 48.42 KB Posted: 7/3/07 Here is the charcole can side of the system after it was replaced. i get a better picture after i in... |  Hits: 421 Size: 55.33 KB Posted: 7/3/07 here is the stock 1983 carb line next to the the EFI line off a 1994 Bronco. |  Hits: 410 Size: 92.75 KB Posted: 7/3/07 here is a better shot of the size difference of the 2 lines. |  Hits: 421 Size: 62.54 KB Posted: 7/3/07 this is the stock clip that holds the line to the frame. I needed the newer larger size line clips b... |  Hits: 429 Size: 66.52 KB Posted: 7/3/07 Here is a side view of the stock clip it fits in a hole in the frame and then the pin spreads the cl... |
 Hits: 461 Size: 59.86 KB Posted: 7/3/07 after looking around at options i decieded some 3/8 hose clips and 1/4 rivets would do the job just ... |  Hits: 424 Size: 65.83 KB Posted: 7/3/07 Here is the new line in the front wheel well to the Charcole can can. |  Hits: 454 Size: 45.49 KB Posted: 7/3/07 Here is the new line running down the frame sorr it was dark but the rubber loop it the tie in to th... |  Hits: 429 Size: 48.06 KB Posted: 7/3/07 here is the rear hard line to the rubber line that connects to the fuel tank. |  Hits: 514 Size: 52.61 KB Posted: 7/3/07 here is another view of the hard line and the new EFI fuel lines. I put a clip at each place a stock... |
 Hits: 442 Size: 43.68 KB Posted: 7/3/07 it is hard to see the main line but it runs inside the frame rail behind the shock and pokes out a h... | | | | |