michael collins > 1983 Ford Bronco > open folder Roof Repair

I had a leak in the front end so i went over the whole top seal. the rear looked in need of help. Th...
Url
Tag
Img
Thumb
I did alot of checking and i found out the flat steel roof flexes the most. I found this sealer just...
Url
Tag
Img
Thumb
I washed the RV (it needed it) and then scrubed the area to be sealed with the alcohol and rags till...
Url
Tag
Img
Thumb
I then cut out the correct size of roof tape. this has a silver side (TOP) and a paper side (this ne...
Url
Tag
Img
Thumb
I started the 1st new seal at the edge of the old seal. there was not enough on the metal to stay se...
Url
Tag
Img
Thumb
i removed a small amount of paper and used the floor roller to roll it into the metal and all the ed...
Url
Tag
Img
Thumb
to make sure there was a good seal i cleaned the whole area again.
Url
Tag
Img
Thumb
the next row sealed 1/2 on the 1st line of roof seal i put down and completly covered the old seal o...
Url
Tag
Img
Thumb
Here is another view of the completed job.
Url
Tag
Img
Thumb
I made sure all air bubbles were worked out. this side is done.
Url
Tag
Img
Thumb
Here is the front as i started it there was a hole in the center of the "V" and it was leaking down ...
Url
Tag
Img
Thumb
I first ran a strip over the center and made sure it was rolled in real good.
Url
Tag
Img
Thumb
you can see i overlapped the old seal and rolled it in good and tight
Url
Tag
Img
Thumb
here is the last view. it now has been several heavey rains and no leaks. i am so happy. job well do...
Url
Tag
Img
Thumb
 
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog