When we got this the wiring was all Hacked up. the coil was not getting full power and there were exposed wires everywhere. so here was the original connection the coil went to the balist resistor, which was no longer needed. there were a few other Ignition hot wires going to the same spot. tme to clean up the rats nest.

i got a few of these kicking around. This is a power take off for a Chevy car. i going to run the 10 guage wire to the Ignition hot on the power switch. the other side will be the ignition power take off.

it is alittle dark, but the balist resistor is out and i mounted the one point take off on the metal frame.

Here is a little better shot the main power feed is connected and the balist is gone and in the trash.

I next ran a new 12 guage wire for the coil. this is looking alot better.