Steering Linkage for Bronco & F150
VIEW A IS INCORRECT - there is no adjusting sleeve at the pitman arm. The main view is correct.
1 Tie Rod Ball Stud (Part of 3A131) (R has RH threads, MotorCraft
MEOE140; L has LH threads, MotorCraft
MEOE141)
2 Tie Rod Adjusting Sleeve 3310 (R is small, MotorCraft
MEOE54 or MES2212R; L is large, MotorCraft
MEOE53 or MES2213L)
3 Tie Rod End Left Inner 3A131 (RH threads, MotorCraft MEOE95)
4 Steering Arm Drag Link (Right Inner) 3304 (LH threads, MotorCraft
MDOE11 or MDS1018 )
5 Drag Link Ball Stud (Part of 3304)
6 Steering Gear Sector Shaft Arm 3590
7 Steering Damper Bracket 3E652
8 Nut & Washer N806889-S56 Tighten to 34-48 N-m (25-35 Lb-Ft)
9 Insulator N806889-S
10 Steering Damper 3281
11 Nut N800895 Tighten to 70-100 N-m (51-73 Lb-Ft)
12 Cotter Pin 642569
13 Tie Rod Adjusting Sleeve Clamp Tighten to 40-57 N-m (30-42 Lb-Ft)
A Tighten to 70-100 N-m (51-73 Lb-Ft)
For replacement tie rod end boots, use 4 Energy 9.13101G.
'80-96 Bronco PS pitman arm engineering number E2TA-3590-GA
See also:
.
.
.
.
.
