shaftage 001.jpg
986 hits | 53.07 KB | Posted: 11/30/07
cut the female slip off yoke #1

shaftage 003.jpg
984 hits | 52.27 KB | Posted: 11/30/07
the yokes have a 1.75" OD, found a piece of 2" .120 wall to serve as a sleeve to join the two slips ...

shaftage 005.jpg
1012 hits | 56.87 KB | Posted: 11/30/07
cut the male slip off driveshaft number #1

shaftage 007.jpg
995 hits | 64.3 KB | Posted: 11/30/07
grafting spline #1 onto shaft #2. angle iron jig.

shaftage 008.jpg
877 hits | 58.78 KB | Posted: 11/30/07
yokes must be lined up before the male splines are welded up. the keyway must be in the right spot.

shaftage 009.jpg
1076 hits | 54.88 KB | Posted: 11/30/07
male splines welded up, ready for grinding.

shaftage 006.jpg
932 hits | 65.88 KB | Posted: 11/30/07
drilling the sleeve tube for plug welds. 3x3/8" for each side.

shaftage 010.jpg
1003 hits | 65.08 KB | Posted: 11/30/07
use the male spline to line up the yokes before you weld them.

shaftage 011.jpg
962 hits | 71.65 KB | Posted: 11/30/07
plug welded

shaftage 012.jpg
966 hits | 64.23 KB | Posted: 11/30/07
also welded the edge of the sleeve. heres a shot of the assembly

shaftage 014.jpg
956 hits | 59.95 KB | Posted: 11/30/07
male splines ground smooth, 10" overall length.

shaftage 015.jpg
986 hits | 63.02 KB | Posted: 11/30/07
10" in the female slip as well

shaftage 016.jpg
1020 hits | 60.86 KB | Posted: 11/30/07
this gives ~8.5" of travel with a minimum spline engagement of 1.5" at full droop

shaftage 018.jpg
990 hits | 47.2 KB | Posted: 11/30/07
yokes ground for high clearance

shaftage 017.jpg
1096 hits | 57.22 KB | Posted: 11/30/07
ready to install

shaftage 020.jpg
1011 hits | 73.8 KB | Posted: 11/30/07