DSC00804.JPG
570 hits | 51.65 KB | Posted: 3/28/07

Ben busting a nut
DSC00806.JPG
559 hits | 65.72 KB | Posted: 3/28/07

The knuckle. The left side of the pic is the top. We cut the stud short.
DSC00807.JPG
518 hits | 55.37 KB | Posted: 3/28/07

The bottom. The lower joint has a snap ring that you must remove. The upper joint does not, althou...
DSC00808.JPG
543 hits | 62.93 KB | Posted: 3/28/07

This is NOT how you press out the bottom joint.
DSC00809.JPG
495 hits | 63.42 KB | Posted: 3/28/07

THIS is how you press out the bottom joint. By the way, you must press the bottom joint out first.
DSC00810.JPG
467 hits | 70.14 KB | Posted: 3/28/07

Both joints removed. We coated the bores with anti-seize before installing the new joints.
DSC00812.JPG
479 hits | 68.44 KB | Posted: 3/28/07

Press the upper joint in first. This is how you set the press up; there's a lip on the joint and on...
DSC00813.JPG
506 hits | 63.92 KB | Posted: 3/28/07

You'll run the threaded rod through the lower joint's bore. This is why you install the upper first...
DSC00815.JPG
475 hits | 66.29 KB | Posted: 3/28/07

Once you've bottomed the joint against the tool (not fully seated in the bore), you'll need to hamme...
DSC00816.JPG
590 hits | 67.1 KB | Posted: 3/28/07

Here's how to set up and press in the lower joint. Don't forget to install the new snapring.

About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2024 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog