Laurits
 |
|
• Fort Walton Beach, FL, USA |
|
• Registered on 11/22/2016 |
|
• 6 posts |
• 1
|
|
 Posted:7/30/2018 13:55 |
|
|
Hi,
I need to ID two fusible links tied to the same connector ring. The factory blobs are marked P14 & P15. Leads going to the ring are both black. On circuit side of the factory blob it has one yellow lead and one black with a yellow stripe. The ring wire crimp shank is split both there are no signs of heat damage. I ran a continuity check from the ring to ground and got an almost dead short, that is it went 3/4 of the way up the scale. |
|