|
|
kimg0174.jpg | Hits: 62 | Posted on: 12/29/19
| View Low-Res
due to the shocks being soo much longer that i should have really used i to change one of the mounting positions so it would not bottom out on collapse. i could not raise the F250 towers higher due to the A/C box so i lowered the bottom mounting point.
i decided the best way to lower it would be drilling a 1/2" hole just below one of the main tubes of my extended radius arms. then use 1/2" steel bushings to extend it out from radius arm. i later welded the bushings to the radius arm for support.
|
