PDRM0272.JPG 2089 hits | 43.67 KB | Posted: 8/9/06 From outside (Posted in: A-Pillar VDO tach and pod install (8/'06))
PDRM0273.JPG 2891 hits | 51.02 KB | Posted: 8/9/06 From door way (Posted in: A-Pillar VDO tach and pod install (8/'06))
pdrm0275.jpg 2203 hits | 44.21 KB | Posted: 8/9/06 From pass seat 1 (Posted in: A-Pillar VDO tach and pod install (8/'06))
PDRM0276.JPG 1987 hits | 59.97 KB | Posted: 8/9/06 From pass dash board (Posted in: A-Pillar VDO tach and pod install (8/'06))
pdrm0277.jpg 2017 hits | 48.55 KB | Posted: 8/9/06 Up close view (Posted in: A-Pillar VDO tach and pod install (8/'06))
PDRM0279.JPG 2178 hits | 64.59 KB | Posted: 8/9/06 Up close view 2
Notice the Door weathstrip molding covers the outer fasteners. The fit was even tighter yesterday, however the included push-pin fasteners relaxed sligthly.
I used a heat gun to mold it to my a-pillar, and trimmed ~1/2" from the... (Posted in: A-Pillar VDO tach and pod install (8/'06))
I tried to wrap with wire loom and electrical tape as factory lookign as possible (Posted in: Fall 2006 - Engine Detail-MM box+04 CVPI zip tube)
PDRM0310.JPG 1777 hits | 36.71 KB | Posted: 9/25/06 Aweful shot of my new B&M transmission cooler
It is dead center of the car, in front of the condensor.
It is bolted to the steel brace in bumper cover, as well as the core support. It feels very solid and secure. (Posted in: Fall 2006 - Engine Detail-MM box+04 CVPI zip tube)