SuperMotors.net Forums

View unread posts | Last 24 hours | Last 48 hours | Last 72 hours | Last 7 days

Forums > SuperMotors Community Discussion > Engine and Drivetrain

1998 crown vic p74 noise

Thread Statistics: Users to Post: 2 | Total Posts: 2 | Total Views: 1316

You must be logged in to post in or subscribe to this thread.

Pages: 1

WAVE1200

• DIX HILLS, NY, USA

• Registered on 5/11/2012

• 5 posts

Posted:5/11/2012 09:04

Hello everyone. I'm new to the forum. I have a 1998 crown vic that has had this noise for a while( maybe 20.000 miles or so and I'm lost . Near the end of the video to make noise go away I stated that i put the car in drive to make it go away, I ment to say i put it in park. Also to bore scope I could not get it all the way up to the flex plate bolts to see any cracks. After I unbolted the flywheel to see if I could see a crack when I bolted the flywheel back up it makes this noise a little louder when the car is first started up in the morning in park and goes away after about 2 minutes. Also sometimes the noise is louder than other times. I have replaced timing guides and i would be upset to remove the transmission to find out the flexplate is good http://www.youtube.com/watch?v=e9taJGnTNRQ&feature=youtu.be

edited 5/11/2012 09:18

wizzard1222

• Ballwin, MO, USA

• Registered on 1/27/2011

• 139 posts

Posted:5/11/2012 15:45

Sorry to "hear" about your issue....

The inclusion of your video clip was very clean and helpful...

Sorry, but I can't be of much help in solving your '"noise"...just
not a transmission/flywheel guy....

I'm sure a better answer will come shortly.....
Have you just taken it to a Tranny shop for their
"Seasoned Knowledge & Experiences"....???

Hope this helps a litttle...

Forums > SuperMotors Community Discussion > Engine and Drivetrain

1998 crown vic p74 noise

Thread Statistics: Users to Post: 2 | Total Posts: 2 | Total Views: 1316

You must be logged in to post in or subscribe to this thread.

Pages: 1