original 350 bored .030 over (355 ci)
flat top pistons
Melling high volume oil pump
mild cam
Edelbrock performer intake
Edelbrock performer 650 carb (#1405)
Edelbrock spring loaded needle & seat (#1465)
Edelbrock Valve Covers
Drivetrain:
TH350 transmission
NP205 transfer case
JB Custom Fab. Twin-Stick T-case shifter
Dana 44 front diff. 3.07 R&P
Front axel relocated 1.5" forward
Corporate 12 rear diff 3.07 R&P
mini-spool in rear
Warn Premium locking hubs
ORD extended brake lines
Notes:
I bought the Blazer about 9 years ago.
ORD rear shackle flip
rough country 4" lift
ORD Zero-Rate in front
Custom fabricated T-case brace (made from a '78 bronco brace)
custom front & rear bumpers
custom metal grill
tall (truck style) automatic shifter on floor
factory roll bar
36" TSL Super Swamper tires
'91 front clip from a Suburban
'85 front fenders from a Custom Deluxe
full top cut into bikini-style
truck tailgate installed
home-made tail light delete panels w/ trailer lights in rear
unclip16.JPG 74 hits | 38.03 KB | Posted: 1/31/08 later i bought better front fenders from a '91 suburban
unclip02.JPG 72 hits | 34.39 KB | Posted: 1/31/08 now the bumper is off, time to work on unbolting the fenders
Early Blue.jpg 71 hits | 66.22 KB | Posted: 1/31/08 very early picture. we drove it to Eureka Springs, AR. for the week end.
unclip19.JPG 68 hits | 40.71 KB | Posted: 1/31/08 i drove it quite awhile without a hood. finally i found a black one with hail damage for $20.
unclip20.JPG 68 hits | 34.77 KB | Posted: 1/31/08 the worst part about my clip swap was the horrible job of cutting and installing the newer hinges. i didnt have the propper tools, so did a hack job with the primative tools i did have
unclip01.JPG 66 hits | 39.97 KB | Posted: 1/31/08 first step is to start unbolting the original front bumper
unclip15.JPG 65 hits | 40.6 KB | Posted: 1/31/08 i didnt have a newer front bumper so i opted to use the original style bumper
broken rear output yoke/T-case got rear wheel hop while climbing a rocky trail and broke the rear output yoke on the NP205 t-case. looking for a stronger solution to fix it.
0.00
08/02/08
Repair
new rotor had to buy a new rotor/hub and replace the bearings on the pass. side.
30.18
07/29/08
Modification
hood pins new hood pins to help keep the hood in check
