01Parts.JPG
141 hits | 102.4 KB | Posted: 7/24/06
Start by finding a good antenna motor & mast, and a dash switch & bezel for your car's year. The da...

02Nut.JPG
164 hits | 74.67 KB | Posted: 7/24/06
Unscrew the fixed mast. There are tools available for the base nut, but it usually comes loose with...

03WheelWell.JPG
156 hits | 71.8 KB | Posted: 7/24/06
Removing the RF tire makes the job MUCH easier, but if that's not possible, steer fully R.

04ScrewT20.JPG
157 hits | 71.51 KB | Posted: 7/24/06
Peel the wheelwell forward to expose the gold T-20 Torx screw, and remove it.

05Mast.JPG
167 hits | 36.23 KB | Posted: 7/24/06
Pull the base down & out of the fender. The black plastic bezel can stay on top of the fender.

06Kick.JPG
184 hits | 88.67 KB | Posted: 7/24/06
Remove the R kick panel for access to the underdash wiring. The antenna wire with the yellow tag ru...

07Motor.JPG
163 hits | 37.42 KB | Posted: 7/24/06
Install the motor, pushing it as far UP as possible before tightening the screw, then install the nu...

08Wires.JPG
158 hits | 89.46 KB | Posted: 7/24/06
The unused 2-pin connector with a Green & a Red wire is for the antenna motor. Route the new antenn...

09Switch.JPG
229 hits | 83.42 KB | Posted: 7/24/06
Remove the original radio bezel, connect & install the new switch, and install the new bezel. The a...

10Ant.JPG
132 hits | 32.94 KB | Posted: 7/24/06
Push the insulation & wheelwell back into place, replace the wheel, and you're DONE!