|
|
Hits: 1036
Size: 63.7 KB
Posted: 10/30/04
The last panel required and I'm new all round; hood, fenders, door shells, tailgate shell, rear quar... | 
Hits: 840
Size: 69.37 KB
Posted: 11/3/04
Metal everywhere the original had metal and bracing just the same places too. | 
Hits: 816
Size: 56.26 KB
Posted: 11/3/04
Remove hood bolts and transfer U-nuts over to new hood. Disconnect underhood light, ground strap a... | 
Hits: 858
Size: 43.25 KB
Posted: 11/3/04
Removed old hood latch tension strap from old hood and reinstalled it on new hood. DO NOT do this u... | 
Hits: 919
Size: 86.82 KB
Posted: 11/3/04
Hood off, cleaning hinges for paint with hood. Good time to remove or tweak cowl panel if you need ... |
Hits: 1038
Size: 70.79 KB
Posted: 11/3/04
New hood on pretty close, just a few tweaks left so she sits perfectly. Can't do that until I raise ... | 
Hits: 842
Size: 80.27 KB
Posted: 11/3/04
Old hood destined for junkyard. Not that bad, but enough rust starting and one or two dents to fix. ... | 
Hits: 964
Size: 34.57 KB
Posted: 11/12/04
Even though the sides and lines line up well, you can see there's a problem with the valance or cowl... | 
Hits: 950
Size: 58.14 KB
Posted: 11/12/04
This under panel was pretty rusty, though curiously the rest of the areas under there were completel... | 
Hits: 912
Size: 36.12 KB
Posted: 11/12/04
Bad angle for the shot as it doesn't show how much closer the valance lines up with the new hood(loo... |
Hits: 949
Size: 36.19 KB
Posted: 11/19/04
There's a better shot. Lined up flush and ready for final paint. BTW I got it flush by beating down ... | | | | |
New hood