Hits: 141
Size: 102.4 KB
Posted: 7/24/06
Start by finding a good antenna motor & mast, and a dash switch & bezel for your car's year. The da... | 
Hits: 164
Size: 74.67 KB
Posted: 7/24/06
Unscrew the fixed mast. There are tools available for the base nut, but it usually comes loose with... | 
Hits: 156
Size: 71.8 KB
Posted: 7/24/06
Removing the RF tire makes the job MUCH easier, but if that's not possible, steer fully R. | 
Hits: 157
Size: 71.51 KB
Posted: 7/24/06
Peel the wheelwell forward to expose the gold T-20 Torx screw, and remove it. | 
Hits: 167
Size: 36.23 KB
Posted: 7/24/06
Pull the base down & out of the fender. The black plastic bezel can stay on top of the fender. |
Hits: 184
Size: 88.67 KB
Posted: 7/24/06
Remove the R kick panel for access to the underdash wiring. The antenna wire with the yellow tag ru... | 
Hits: 163
Size: 37.42 KB
Posted: 7/24/06
Install the motor, pushing it as far UP as possible before tightening the screw, then install the nu... | 
Hits: 158
Size: 89.46 KB
Posted: 7/24/06
The unused 2-pin connector with a Green & a Red wire is for the antenna motor. Route the new antenn... | 
Hits: 229
Size: 83.42 KB
Posted: 7/24/06
Remove the original radio bezel, connect & install the new switch, and install the new bezel. The a... | 
Hits: 132
Size: 32.94 KB
Posted: 7/24/06
Push the insulation & wheelwell back into place, replace the wheel, and you're DONE! |
Power Antenna