|
|
'93-95 Bronco Engine Bay LHR IF THE IMAGE IS TOO SMALL, click it. This cruise servo was only used from '93-04. Only '93-96 Broncos have 4WABS. '96-up DLC is under the dash. To remove the EEC, back out the 10mm bolt recessed in the center of its connector, set the connector aside, remove the 2 11mm nuts (above & below), then pull the EEC & its weather seal straight forward into the engine bay. It may be necessary to bend the plastic wheelwell liner to make room. See also:  .  .  .  .  .  .  .  See also: MotorCraft 2016 Wiring Pigtail Guide
|
|