Bowtie Blazer
 |
|
• Baton Rouge, LA, USA |
|
• Registered on 5/27/2003 |
|
• 1,220 posts |
|
|
|
 Posted:2/29/2004 21:29 |
|
|
8 lug conversion stuff for a ten bolt, ford chevy, whatever
th400 HD K-case chevy small or big block
th400 np205 or np208 adaptor 32 spline
np208
two rear drive shafts
2wd ch465, bell housing z-bar and all pedals (chevy tranny)
extra bell housing
c30 rear springs
14ff backing plates and drums 13" kind
 |
|
Wildman
 |
|
• Meraux, LA, USA |
|
• Registered on 8/15/2003 |
|
• 301 posts |
|
|
|
|
Posted:2/29/2004 21:47 |
|
|
Josh I still have the tuned port injection set up, if you want to horse trade for the th400 setup
 |
|
schmuck
 |
|
• nola, XX, USA |
|
• Registered on 5/21/2003 |
|
• 1,187 posts |
• 1 Vehicle
|
|
|
Posted:2/29/2004 22:14 |
|
|
how long are the c30 springs
nucking futs
|
|
Bowtie Blazer
|
|
• Baton Rouge, LA, USA |
|
• Registered on 5/27/2003 |
|
• 1,220 posts |
|
|
|
|
Posted:2/29/2004 22:22 |
|
|
i'm still debating on the TPI setup, and I may still get it from you, as far as horse trading i'm trying to recoup some of the tons of money i have spent lately on MODS and have a few outright offers just checking local intrest first. So I may just outright purchase it from you
|
|
Bowtie Blazer
|
|
• Baton Rouge, LA, USA |
|
• Registered on 5/27/2003 |
|
• 1,220 posts |
|
|
|
|
Posted:2/29/2004 22:31 |
|
|
also got this in an e-mail today from the gulfcoast guys
The following parts are for sale, the contact info is below.
1) Rear Axle - Dana 70 off a Ford Dually. Has 411 gears.
2) 435 Ford transmission with a 205 transfer case. If needed I have an
advanced adpter bellhousing that will bolt this to a small block chevy.
3) 1991 Jeep Cherokee body and running gear. No motor.
4) Axles for a YJ spring over. These axles are set up for a YJ
springover but
would also be a good conversion for a CJ or TJ.
Front - Currie built Dana 44 axle with chromoly axle shafts, new
Detroit
locker, 513 gears, high clearance steering and Warn premium lockout
hubs.
Rear - Ford 9 inch with 33 spline chromoly Moser axle with a full
spool,
513 gears and disk breaks.
M.O.R.E. shackle reversal kit and buggy springs.
5) NP 231 transfer case with tail shaft kit.
6) 5 38 x 14.50 TSL/SX Super Swampers
4 Mounted on 15 x 12 Eaton beadlocks 5 x 5 1/2 lug pattern. 80%
tread
remaining.
5th tire is new. Mounted on a 15 x 10 steel wheel. Used as spare.
Please contact Bob Taylor at 251-607-9280, 251-423-6233 or email at
[email protected]
|
|
