XMen
 |
|
• Phoenix, AZ, USA |
|
• Registered on 6/19/2004 |
|
• 18 posts |
• 1
|
|
 Posted:7/12/2004 18:33 |
|
|
|
On the 04 X...are the Elblems removable with out leaving holes in the fender...They look like they are just put on with form tape...Thanks |
|
LANDYOT
 |
 | 
• Subscriber since 11/23/2003 |
|
• Newport News, VA, USA |
|
• Registered on 7/15/2003 |
|
• 1,110 posts |
|
|
|
|
Posted:7/12/2004 19:48 |
|
|
|
Typically, plastic car badges / emblems have alignment pins for the assembly-line folks to use as a positioning guide, and are held in place with double-back tape. So, I'd almost bet $$$ that there are holes in the sheet metal behind your emblems. I purchased a Ford "Triton V10" emblem to place on my rear door, and if I recall correctly, I had to remove at least one alignment pin before sticking it to a plain surface. |
|
XMen
|
|
• Phoenix, AZ, USA |
|
• Registered on 6/19/2004 |
|
• 18 posts |
• 1
|
|
|
Posted:7/12/2004 20:09 |
|
|
|
Thats what I was afraid of...I'm just going to have to order a set and have them chrome black...Thanks |
|
rozett
 |
|
• Limington, ME, USA |
|
• Registered on 1/10/2003 |
|
• 163 posts |
• 1
|
|
|
Posted:7/12/2004 21:20 |
|
|
I bought 3 V10 badges two years ago. They had the double-sided tape but no alignment pins.. I just used a ruler to line them up, took off the backing and stuck 'em on.
//bruce
2000 Excursion Limited V10 4x4
ART brakes, Rancho RSX shocks, Hellwig rear sway bar, SD grille, V10 badges, Sylvania Silverstars, clear corners, and Bridgestone Dueler A/T REVO 285s. |
|
TexasX
 |
|
• Galveston, TX, USA |
|
• Registered on 5/13/2004 |
|
• 61 posts |
• 1
|
|
|
Posted:7/13/2004 08:54 |
|
|
Did you all buy the emblems at your local Ford dealer or online? If, online, can you provide a URL, Thanks!
TexasX
MUST SELL! Check the Classified Forum >> MAKE ME AN OFFER - 17,661.08 Pay-Off and it's yours |
|
LANDYOT
|
|
• Subscriber since 11/23/2003 |
|
• Newport News, VA, USA |
|
• Registered on 7/15/2003 |
|
• 1,110 posts |
|
|
|
|
Posted:7/13/2004 15:08 |
|
|
|
Bought mine at a dealer ... Bowditch Ford in Newport News, VA. |
|
rozett
|
|
• Limington, ME, USA |
|
• Registered on 1/10/2003 |
|
• 163 posts |
• 1
|
|
|
Posted:7/14/2004 05:22 |
|
|
I bought my parts at http://www.fordpartsonline.com/.
//bruce
2000 Excursion Limited V10 4x4
ART brakes, Rancho RSX shocks, Hellwig rear sway bar, SD grille, V10 badges, Sylvania Silverstars, clear corners, and Bridgestone Dueler A/T REVO 285s. |
|
TexasX
|
|
• Galveston, TX, USA |
|
• Registered on 5/13/2004 |
|
• 61 posts |
• 1
|
|
|
Posted:7/14/2004 08:14 |
|
|
I couldn't find the emblems on the site? 
MUST SELL! Check the Classified Forum >> MAKE ME AN OFFER - 17,661.08 Pay-Off and it's yours |
|
Excursionluvr
 |
|
• James City County, VA, USA |
|
• Registered on 1/28/2004 |
|
• 6 posts |
|
|
|
|
Posted:7/14/2004 11:47 |
|
|
|
We bought ours at www.fordpartsonline.com as well. We could not find them on the site either, e-mailed them and they told us the part number to look up on their site. We did and then we ordered them. Try e-mailing them, they were not that expensive....I am sure alot cheaper than the dealer wouold be!! Good Luck!! |
|
Lou Beckler
 |
|
• Wakeman, OH, USA |
|
• Registered on 4/27/2003 |
|
• 43 posts |
• 1
|
|
|
