FordExcursions.com Forums
Raction
 |
|
• New Albany, IN, USA |
|
• Registered on 1/23/2006 |
|
• 1 post |
|
|
|
 Posted:2/5/2006 11:36 |
|
|
I just bought a 2000 Excursion Limited w/5.4. looking for radius rods (i'm on Landyots list but maybe someone has used?) Early 2000 model. i would also like to upgrade to the tow mirrows. Any other ideas or must have's?) i am open you everyones suggestions...
|
|
jscarb2
 |
|
• MANTEO, NC, USA |
|
• Registered on 10/25/2005 |
|
• 10 posts |
|
|
|
|
Posted:2/13/2006 21:30 |
|
|
|
i am pretty sure the first and second generation radius rods will not work on an early 2000, if your calipers are not on the same sides of the wheels. i do however think he told me the new third generation will. you need to check with him to make sure! |
|
LANDYOT
 |
 | 
• Subscriber since 11/23/2003 |
|
• Newport News, VA, USA |
|
• Registered on 7/15/2003 |
|
• 1,110 posts |
|
|
|
|
Posted:3/4/2006 09:05 |
|
|
Just to provide a little bit of clarification, the GEN-I rods will NOT fit on an early-2000 model ... and that was the whole reason the GEN-II rods were developed.
The GEN-II rods have since been upgraded to "GEN-III" because the axle-clamps have been changed. Trimming the metal bump-stops in the spring-pack was required to install the GEN-II rods, but trimming is not required with the GEN-III design.
Raction - Sorry, but I don't know of anyone looking to sell their radius-rods. Good luck in your search. BTW, I have seen them pop up on eBay every now and then. |
|
|
|
