SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”

Probe-Enthusiast.com Forums

View unread posts   |   Last 24 hours   |   Last 48 hours   |   Last 72 hours   |   Last 7 days

probe-enthusiasts Forums > probe-enthusiasts Discussion > General Discussion
Starting Point
Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 735
You must be logged in to post in or subscribe to this thread.Pages: 1
Prober_91
• Newport, OR, USA
• Registered on 8/18/2005
• 4 posts
Posted:8/22/2005 14:24
I just bought my wife a 91 Probe LX with the 3.0 V6. It started and ran fine after a new battery was installed, but days later all I get is a relay click and all power seems cut to the rest of the car. Each day the radio is reset, like the battery terminals were disconnected. My friend, the wire wiggler, got it to start a couple of times more, when the relays clicked, but it seems there are some gremlins in my electrical system. Because it won't even turn over, I cannot get it in for diagnostics, but when there is power to the ignition, it starts BAM! Does anyone have a point for me to start? No pun intended :-)
dnevins  
Subscriber
• Subscriber since 12/29/2009
• San Diego, CA, USA
• Registered on 12/28/2009
• 410 posts
Posted:10/22/2026 22:37
The radio losing its presets every day is the best clue you have: that only happens when the whole car loses battery power, which a single bad relay cannot do. Something between the battery and the rest of the car is opening and closing, and the "wire wiggler" getting it to start fits that too.

Check these in order:

1. Both battery clamps. Take them off, clean the posts and the inside of the clamps to bright metal, and look for corrosion that has crept up under the cable insulation. A new battery on old crusty clamps is a common way to end up here.
2. The ground cables: battery negative to the engine and to the body. Follow them to both ends and clean and tighten them.
3. The main fuse (the big fusible link) in the underhood fuse box, and the terminals it bolts to. A loose or cracked one there cuts power to everything.

To find it fast, turn the headlights on and wiggle each cable and connection one at a time. When the lights flicker or go out, you have found it.

Dana


https://partslogic.com
probe-enthusiasts Forums > probe-enthusiasts Discussion > General Discussion
Starting Point
Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 735
You must be logged in to post in or subscribe to this thread.Pages: 1