blktc0017.jpg 795 hits | 87.94 KB | Posted: 6/17/04 (Posted in: Initial)
Lincoln-vs-maxima.JPG 794 hits | 35.18 KB | Posted: 1/30/04 (Posted in: 2004)
IMG_0008.JPG 794 hits | 39.86 KB | Posted: 8/3/07 Yeah, that's daylight you're looking at, out the end. The guys on the Bronco forum are thrilled with this muffler compared to Flowmasters. I'm going on faith it won't be too loud. The 3" cat and ridiculous tailpipe routing should also help keep it ac... (Posted in: Hooker Areochamber muffler)
IMG_0120.JPG 792 hits | 75.87 KB | Posted: 8/8/05 All back together on the passenger's side. The driver's side took 10 minutes compared to the two hours I spent messing around on this side. Note the properly repaired air pump diverter valve vacuum hose boot ! No more vacuum leak. (Posted in: The Cheapest Autolite plugs money can buy)
Town Car-5.jpg 790 hits | 44.24 KB | Posted: 8/1/03 (Posted in: 2003 Pics)
IMG_0196.JPG 790 hits | 70.92 KB | Posted: 9/28/05 The stock temp sensor was clocked right over the T-stat housing. Using a 1" deep socket I just tightened the stock temp sensor tower so it pointed slightly to the left and I was back in business. (Posted in: Taurus Electric Fan)
IMG_0016.JPG 790 hits | 75.06 KB | Posted: 2/27/08 Here's the two corroded terminals, busted loose out of the crumbling original connector, soaking in two straws filled with vinegar (acid). (Posted in: Fuel sending unit harness)
EPSN0001.JPG 789 hits | 69.39 KB | Posted: 12/3/04 hard to see hood ornament (Posted in: Exterior)
IMG_0142.JPG 788 hits | 75.74 KB | Posted: 8/8/05 There's that beautiful, though very conspicuous, MSD coil up front and proud of it. Maybe a give it a shot of black paint to conceal it's identity ? (Posted in: MSD Coil)
Lincoln new year pics-sea side-sig.jpg 787 hits | 9.92 KB | Posted: 1/7/04 (Posted in: Photo's)
IMG_0009.JPG 787 hits | 24.26 KB | Posted: 8/24/05 This is how you get the broken plastic vacuum line out of the angled rubber vacuum boot. Just screw in a sharp drywall stud screw and pull on it and out pops the broken plastic line. Then you can slip the boot over the shorter line, no vacuum leak ! (Posted in: The Cheapest Autolite plugs money can buy)
Town Car-4.jpg 786 hits | 58.86 KB | Posted: 8/1/03 (Posted in: 2003 Pics)
horns1.JPG 785 hits | 59.86 KB | Posted: 10/17/03 (Posted in: album 1)
IMG_0381.JPG 785 hits | 50.9 KB | Posted: 4/27/09 Like it never happened ! (Posted in: Minor collision repair)
IMG_0086.JPG 784 hits | 67.79 KB | Posted: 8/24/05 I always glue these gaskets onto the filter with a little Permatex UltraCopper, just to make sure they stay on during re-assembly. (Posted in: Transmission Filter Change)
drag radial run.WMV 783 hits | 850.45 KB | Posted: 7/6/04 0-160kmh run on the Drag Radials (Posted in: 2004)
edl-3320.jpg 783 hits | 27.72 KB | Posted: 7/6/04 Edelbrock IAS Shocks (Posted in: Suspension)
DSC00885.JPG 782 hits | 20.01 KB | Posted: 6/30/03 (Posted in: album 1)
IMG_0035.JPG 781 hits | 62.91 KB | Posted: 8/30/05 After it's sound beating, the "modified" bracket now only requires an 1/8" clearance grinding(marked in white paint) to allow the use of it's adjustment slot with the 3G alternator. (Posted in: 3rd Generation 130 amp alternator)
Gears installing kit box.JPG 780 hits | 31.77 KB | Posted: 9/25/03 Richmond Gear Mega Installation Kit
(Posted in: Drivetrain Parts)
IMG_0051.JPG 779 hits | 62.55 KB | Posted: 9/16/05 This is the 3" Catco cat I always use. It's a 3 stage, stand alone cat with an air pipe to hook up to the air pump. No it's not stainless and no it's not highflow, but it's $40 and..... Newsflash ! 3" cats flow an awful lot more than 2" units. (Posted in: Catco Catalytic Converter 3")
IMG_0223.JPG 778 hits | 47.22 KB | Posted: 9/28/05 This pic is way out of focus, but maybe you can see the notched angle steel, ready to accept and locate the stock Lincoln overflow tank's lower tab. (Posted in: Taurus Electric Fan)
DSC00891.JPG 777 hits | 24.92 KB | Posted: 6/30/03 (Posted in: album 1)
IMG_0074.JPG 776 hits | 52.33 KB | Posted: 8/24/05 State of the trans was told by the fluid in the pan. Not bad for a used car with almost 100 k on it, I'm fairly happy. It should be stated that after the fluid and filter change the trans shifted noticeably better. (Posted in: Transmission Filter Change)
IMG_0047.JPG 776 hits | 22.45 KB | Posted: 2/27/08 That's the best shot I could get of the little "tangs" on the terminal clips. You get four terminal clips with the connector, but you should be able to re-use your stock wires as they don't seem to deteriorate like the connector does. (Posted in: Fuel sending unit harness)
IMG_0106.JPG 775 hits | 81.04 KB | Posted: 8/8/05 The passenger's side plugs are now reasonably accessible to creative types, with plenty of tools. I don't know how I'd have got to them without removing the air pump diverter valve. (Posted in: The Cheapest Autolite plugs money can buy)
IMG_0031.JPG 775 hits | 42.45 KB | Posted: 9/16/05 Weld a cat or muffler to this fine collector pipe and you'll get one use of this pipe for all time. Now weld a 3" header collector flange, as placed on the 3" end of the pipe, and you're choices are limitless. (Posted in: Flowmaster 3" Y collector)
IMG_0064.JPG 774 hits | 33.64 KB | Posted: 9/16/05 It's nearly impossible for a camera to show you that you can practically read through these cats, so flow is not an issue in my experiance. (Posted in: Catco Catalytic Converter 3")
EPSN0007.JPG 772 hits | 38.21 KB | Posted: 12/8/04 (Posted in: broken)
My Town Car sign.jpg 771 hits | 9.5 KB | Posted: 10/10/03 (Posted in: Photo's)
IMG_0018.JPG 771 hits | 47.24 KB | Posted: 9/17/07 Plenty of clearance around the airbag and the tank (Posted in: Impala SS tailpipe)
new3.jpg 770 hits | 50.91 KB | Posted: 6/30/03 my car 3 (Posted in: album 1)
Oil Cooler (1).JPG 770 hits | 33.33 KB | Posted: 7/6/04 B&M Transmission Oil Cooler (Posted in: Drivetrain Parts)
blue3.jpg 770 hits | 71.19 KB | Posted: 10/14/04 (Posted in: Engine)
IMG_0067.JPG 770 hits | 49.07 KB | Posted: 8/6/05 Just pop the six of these plastic clips out with a trim tool. (Posted in: Large Transmission Cooler)
IMG_0113.JPG 770 hits | 54.68 KB | Posted: 8/8/05 If you've ever torn off a plug boot or terminal you'll appreciate why I always load both ends of the plug wire with dielectric grease. It stops rip-offs happening and helps promote conductivity. (Posted in: Ford Racing 9mm Spiral Core wires)
IMG_0077.JPG 769 hits | 62.72 KB | Posted: 8/24/05 Simply snug the nut to the inside of the pan, using an old drain bolt and the plastic washer on the other side. The reason is without the washer, which will melt, we welded the bolt to the pan ! (Posted in: AOD drain pan bolt)
IMG_0005.JPG 769 hits | 66.53 KB | Posted: 9/29/06 Think I've got enough Tee holders ? A local seamstress sewed them up for me and I just "gooped" them on. (Posted in: Golf Bag)
ens-9-8117r.jpg 768 hits | 11.71 KB | Posted: 7/6/04 Energy Suspension Sway Bars Endlinks (Posted in: Suspension)
DSC00774.JPG 767 hits | 42.16 KB | Posted: 6/30/03 (Posted in: album 1)
riceboysinstallingaltezzas.jpg 767 hits | 42.16 KB | Posted: 6/30/03 (Posted in: Other)
Town Car - 3 inch drop.WMV 767 hits | 2.57 MB | Posted: 5/28/04 video shows my car with 3 inch drop front and 1.5 inch rear (Posted in: 2003)
Lincoln new year pics-sea side (2).jpg 767 hits | 43.95 KB | Posted: 1/2/04 (Posted in: 2004)
Crown Vic PI doing 245 kmh.WMV 766 hits | 2.19 MB | Posted: 8/10/04 99 Crown Vic PI doing +240 kmh (Posted in: Video's)
Town Car 126.jpg 765 hits | 40.48 KB | Posted: 8/1/03 (Posted in: 2003 Pics)
|