Picture 009.jpg
893 hits | 79.96 KB | Posted: 5/23/04
(Posted in: ss)

IMG_0024.JPG
893 hits | 54.62 KB | Posted: 2/27/08
One of the terminals plugged into the new connector. Note the rubber barbs that keep it weather proof. On the loose black wire note the tang on the metal clip. That clicks into the connector to hold them in.
(Posted in: Fuel sending unit harness)

IMG_0055.JPG
892 hits | 81.23 KB | Posted: 8/24/05
In this dandy shot you can see all three of the 8mm bolts holding the filter on and the dipstick still probing for ATF.
(Posted in: Transmission Filter Change)

Colder Plugs & 180F Stat.jpg
891 hits | 39.72 KB | Posted: 1/4/04
12C Spark Plugs & 180F Thermostat
(Posted in: Engine Parts)

Picture 010.jpg
890 hits | 58.69 KB | Posted: 5/23/04
(Posted in: ss)

Riverdale 41st reuion 029.jpg
890 hits | 55.61 KB | Posted: 11/21/06
(Posted in: VoodooLinc)

96' Grand Marquis Burning rubber.mpg
889 hits | 1.3 MB | Posted: 8/13/04
96 Grand Marquis burning rubbers
(Posted in: Video's)

IMG_0007.JPG
888 hits | 58.24 KB | Posted: 2/25/08
Fuel pump had been cutting out.
(Posted in: Fuel sending unit harness)

Town Car 019.jpg
887 hits | 36.48 KB | Posted: 8/1/03
(Posted in: 2003 Pics)

IMG_0091.JPG
887 hits | 42.42 KB | Posted: 8/24/05
New drain plug and washer going in. I like to use the exact size and bolt as the oil pan, to keep the number of spares I need to carry to a minimum.
(Posted in: AOD drain pan bolt)

IMG_0202.JPG
885 hits | 69.42 KB | Posted: 11/29/05
There's the large case Taurus 3rd generation 130 amp alternator in place. Note the adjustment bracket's slot has been widened enough that it now requires a larger washer.
(Posted in: 3rd Generation 130 amp alternator)

Town Car-interior-2.jpg
884 hits | 45.37 KB | Posted: 8/1/03
(Posted in: Interior)

CVN-Sign (1).JPG
882 hits | 9 KB | Posted: 7/8/03
CVN sign
(Posted in: Photo's)

IMG_0053.JPG
880 hits | 42.82 KB | Posted: 9/19/05
A little work with the hacksaw and we're back in business, on the passenger's side.
(Posted in: Y-pipe install day)

IMG_0003.JPG
877 hits | 43.66 KB | Posted: 9/16/05
My die grinder made short work of opening them up until they were plenty big enough to accept the Lincoln's manifold studs. A normal power drill would do the same thing, just takes more time.
(Posted in: Manifolds to Flowmaster Y)

IMG_0034.JPG
876 hits | 60.68 KB | Posted: 2/27/08
Pin terminals cleaned of corrosion and lubed up with dielectric grease.
(Posted in: Fuel sending unit harness)

Ring & Pinion 007.jpg
874 hits | 31.81 KB | Posted: 9/25/03
Ford Racing 3.55 gears, PN: M-4209-G355
(Posted in: Drivetrain Parts)

292475_im_____1_gsi.jpg
874 hits | 9.25 KB | Posted: 3/3/10
My current 15 foot ball retriever
(Posted in: Golf Bag)

IMG_0117.JPG
871 hits | 50.59 KB | Posted: 8/30/05
Plenty of room for the 3G alternator's adjustment bolt to run in the newly modified slot in the bracket.
(Posted in: 3rd Generation 130 amp alternator)

IMG_0037.JPG
871 hits | 66.44 KB | Posted: 2/27/08
New connector click satisfyingly into place and that muther fired right up ! The $6.00 fix !!!!!!!!! You gotta love it ! I'm going to replace every fuel line in the car come Spring !
(Posted in: Fuel sending unit harness)

TCBox2.jpg
869 hits | 66.44 KB | Posted: 6/29/03
(Posted in: Parts)

IMG_0015.JPG
866 hits | 63.26 KB | Posted: 9/25/05
As you can see there is an offset to match up with the stock muffler. I ran 2 1/4" all the way into a muffler with a 2 1/4" inlet and a 2" outlet (to match the tailpipe).
(Posted in: Y-pipe install day)

DSC00809.JPG
864 hits | 41.65 KB | Posted: 6/30/03
(Posted in: album 1)

Dodge Tires 003.jpg
864 hits | 67.99 KB | Posted: 9/30/04
(Posted in: Photo's)

IMG_0234.JPG
862 hits | 74.87 KB | Posted: 11/26/08
O2 sensor wire hooked back up.
(Posted in: Shorty headers)

IMG_0373.JPG
862 hits | 45.65 KB | Posted: 4/27/09
Now you can pull the side body bumper trim back and wedge a large screwdriver in, to allow enough access to get the plastic poppers out.
(Posted in: Minor collision repair)

3rd.My Camry vs. Maxima_2-2.jpg
860 hits | 15.76 KB | Posted: 7/8/03
Camry v6 VS. Maxima
(Posted in: Photo's)

12.jpg
859 hits | 59.39 KB | Posted: 12/5/03
Picture 11
(Posted in: 1985 TC)

IMG_0374.JPG
859 hits | 59.08 KB | Posted: 4/27/09
Two of the screws are accessed reasonably easily. This screw would have required the removal of the whole bumper cover.......or just a notch with a carpet knife, like I did. It's all miles underneath the cover and will never be seen, so I sliced away...
(Posted in: Minor collision repair)

IMG_0033.JPG
858 hits | 49.41 KB | Posted: 8/30/05
As you can see from the pic the adjustment slot in the bracket is about 1" too low for the 3G alternator's bolt hole.
(Posted in: 3rd Generation 130 amp alternator)

IMG_0011.JPG
858 hits | 63.06 KB | Posted: 9/25/05
Ground clearance is good and everything is actually higher than the engine crossmember.
(Posted in: Y-pipe install day)

Meziere Water Pump 2.jpg
857 hits | 76.58 KB | Posted: 8/25/04
Meziere Electrical Water Pump - 9.9 WHP gain
(Posted in: Engine Parts)

Town Car- seats.jpg
857 hits | 57.43 KB | Posted: 8/1/03
(Posted in: Interior)

355 gears box.JPG
856 hits | 54.12 KB | Posted: 9/25/03
Ford Racing 3.55 gears, PN: M-4209-G355
(Posted in: Drivetrain Parts)

IMG_0101.JPG
856 hits | 77.39 KB | Posted: 8/8/05
Somewhere under that plumbing nightmare, on the passenger's side, are four plugs that need changing ! Note the previous owner's electrical tape repair on the air pump vacuum line ! Wonder how many pounds of vacuum electrical tape is good for ? Think ...
(Posted in: The Cheapest Autolite plugs money can buy)

IMG_0060.JPG
853 hits | 65.89 KB | Posted: 8/24/05
There's two of the filter bolts. Expect a second deluge of fluid when you remove the filter from the valve body. Your hair has been warned !
(Posted in: Transmission Filter Change)

new2.jpg
852 hits | 37.26 KB | Posted: 6/30/03
my car 2
(Posted in: album 1)

Meziere Water Pump 4.jpg
852 hits | 73.77 KB | Posted: 8/25/04
Meziere Electrical Water Pump - 9.9 WHP gain
(Posted in: Engine Parts)

Town Car 014.jpg
850 hits | 33.67 KB | Posted: 8/1/03
(Posted in: Interior)

11.jpg
850 hits | 66.42 KB | Posted: 12/5/03
Picture 10
(Posted in: 1985 TC)

Town Car-2.jpg
848 hits | 59.37 KB | Posted: 8/1/03
(Posted in: 2003 Pics)

Town Car-1.JPG
842 hits | 53.34 KB | Posted: 8/1/03
(Posted in: 2003 Pics)

IMG_0081.JPG
842 hits | 63.7 KB | Posted: 8/24/05
I'd say we got weld penetration, wouldn't you ? Once I pulled out the old bolt I just ground the weld flat to the pan until smooth and shot that area with paint to prevent rust.
(Posted in: AOD drain pan bolt)

IMG_0109.JPG
842 hits | 47.33 KB | Posted: 10/6/08
Unserviceable my @$$. If you think I'm shelling out good coin, when there's little else wrong with the original that glue and clamps will fix, think again Ford !
(Posted in: Door lock actuator)

14.jpg
837 hits | 48.28 KB | Posted: 12/5/03
Picture 13
(Posted in: 1985 TC)