CV PI Doing +240 kmh.JPG
836 hits | 46.86 KB | Posted: 8/10/04
Crown Vic PI doing +240 kmh (clear pic)
(Posted in: Photo's)

Riverdale 41st reuion 022.jpg
835 hits | 69.6 KB | Posted: 11/21/06
(Posted in: VoodooLinc)

IMG_0075.JPG
834 hits | 69.89 KB | Posted: 8/24/05
First drill a pilot hole then drill it out to 1/2" and de-burr the hole. Why did I decide to drill right there ?
(Posted in: AOD drain pan bolt)

IMG_0001.JPG
834 hits | 59.86 KB | Posted: 2/25/08
Just a bit of corrosion on the pins
(Posted in: Fuel sending unit harness)

IMG_0368.JPG
833 hits | 53.28 KB | Posted: 4/27/09
These are the two poppers I need to get out.
(Posted in: Minor collision repair)

IMG_0041.JPG
832 hits | 47.65 KB | Posted: 8/30/05
Trusty die grinder to the rescue.
(Posted in: 3rd Generation 130 amp alternator)

IMG_0018.JPG
831 hits | 66.1 KB | Posted: 2/25/08
It would work and then it would die, almost like a bad ground
(Posted in: Fuel sending unit harness)

town car sig2.jpg
829 hits | 10.78 KB | Posted: 11/10/03
(Posted in: Photo's)

IMG_0058.JPG
828 hits | 51.37 KB | Posted: 9/28/05
Derale makes this adjustable fan controller, with a "wet" sensor that screws into your cooling system and takes the actual coolant temperature.
(Posted in: Taurus Electric Fan)

IMG_0005.JPG
827 hits | 29.94 KB | Posted: 2/27/08
The rubber barbs, on the stock wires, seal into each of these holes on the new connector
(Posted in: Fuel sending unit harness)

len1.jpg
826 hits | 24.18 KB | Posted: 6/30/03
sig
(Posted in: album 1)

My Town Car 02.jpg
826 hits | 28.7 KB | Posted: 10/10/03
powerbraking, you can see the chrome trim is painted (Town Car Touring style)
(Posted in: 2003 Pics)

EPSN0009.jpg
825 hits | 38.66 KB | Posted: 9/14/04
Big Pimp'N
(Posted in: Exterior)

IMG_0046.JPG
825 hits | 40.22 KB | Posted: 8/1/07
It's worth noting that CV in the first pic is using stock Chevy 2 1/4" tailpipes. Probably didn't know about Dynomax units that were 2 1/2" and mandrel bent. Can you see what I'm up to yet ?
(Posted in: Impala SS tailpipe)

IMG_0067.JPG
825 hits | 71.02 KB | Posted: 10/6/06
Gently disconnect the vacuum lines and electrical connectors, noting where they go
(Posted in: Upper intake removal/replacement)

IMG_0371.JPG
824 hits | 39.3 KB | Posted: 4/27/09
Removing the body side bumper trim from the driver's front wheelwell is just two philips screws.
(Posted in: Minor collision repair)

09.jpg
820 hits | 56.16 KB | Posted: 12/5/03
Picture 8
(Posted in: 1985 TC)

Crown Vic PI doing 250kmh.jpg
819 hits | 27.84 KB | Posted: 8/10/04
99 Crown Vic doing +240 kmh
(Posted in: Photo's)

Detroit True Trac LSD-1.jpg
818 hits | 23.94 KB | Posted: 9/25/03
Detroit TrueTrac LSD, PN: 913A361 with Timken carrier bearings and races
(Posted in: Drivetrain Parts)

IMG_0200.JPG
818 hits | 51.18 KB | Posted: 9/17/06
There's two of the spare tire anchoring points
(Posted in: Trunk carpet removal)

IMG_0327.JPG
818 hits | 33.21 KB | Posted: 2/19/09
valve
(Posted in: Thermactor emissions valve)

IMG_0028.JPG
817 hits | 40.1 KB | Posted: 9/16/05
Looking down the business end it's not hard to imagine this flows a lot of gases, very efficiently.
(Posted in: Flowmaster 3" Y collector)

IMG_0113.JPG
817 hits | 75.96 KB | Posted: 9/28/05
Nabbed a Taurus fan off a 3.8 litre Taurus because they flow more than enough air to cool a 5.8, let alone a stock 5.0 litre, like mine. Charge ? $40 Canadian
(Posted in: Taurus Electric Fan)

ens-9-5165r.jpg
815 hits | 18.09 KB | Posted: 7/6/04
Energy Suspension Sway Bars Bushings
(Posted in: Suspension)

IMG_0113.JPG
815 hits | 74.34 KB | Posted: 8/30/05
I just added washers onto the water pump studs, behind the bracket, to space it out far enough for the bracket to fit the large case 3G alternator.
(Posted in: 3rd Generation 130 amp alternator)

town car new 2.jpg
814 hits | 26.49 KB | Posted: 11/10/03
*NEW*
(Posted in: 2003 Pics)

blktc0002.JPG
813 hits | 70.63 KB | Posted: 6/13/04
(Posted in: Initial)

IMG_0043.JPG
812 hits | 65.09 KB | Posted: 8/24/05
Not only was I copying the Ford Racing pan's bolt location, but where my finger is pointing is the only fairly deep "well" area that the drain bolt won't interfere with anything.
(Posted in: AOD drain pan bolt)

DSCF0239.JPG
812 hits | 74.96 KB | Posted: 6/24/08
Here's a shot of the front passenger's side fuel and vapour lines clamped down by the clips and 10 mm bolt. I lubed under the clamp with rustproofing grease to TRY to slow down the line corrosion.
(Posted in: Fuel lines)

07.jpg
811 hits | 65.19 KB | Posted: 12/5/03
Picture 7
(Posted in: 1985 TC)

29209295365_0_1.jpg
810 hits | 73.05 KB | Posted: 7/9/04
melted rubber in the tank
(Posted in: broken)

IMG_0064.JPG
810 hits | 62.2 KB | Posted: 8/6/05
To mount it between the A/C condenser and the grill, in the airflow, you need as much access as you can get for the install. This cover needs to come off.
(Posted in: Large Transmission Cooler)

IMG_0218.JPG
809 hits | 69.45 KB | Posted: 11/27/05
Here's a better shot of the resevoir retaining slot I fabbed up. Maybe you can make out the stick-on foam rubber I stuck on to prevent rubbing.
(Posted in: Taurus Electric Fan)

IMG_0006.JPG
806 hits | 32.2 KB | Posted: 2/27/08
The metal tangs slip into the little recesses to the left of each socket hole with a satisfying positive "click", locating the terminals right where you want them, once and for all !
(Posted in: Fuel sending unit harness)

IMG_0202.JPG
805 hits | 53.91 KB | Posted: 9/28/05
I grabbed a replacement T-stat housing, with a threaded provision for the sensor, for $18 CDN. After sticking in the sensor, and soldering in a quick disconnect wire, I realised there was a sensor above the T-stat housing already in the way, preventi...
(Posted in: Taurus Electric Fan)

EPSN0010.JPG
802 hits | 15.48 KB | Posted: 12/8/04
(Posted in: broken)

IMG_0014.JPG
802 hits | 57.21 KB | Posted: 9/16/05
The hole centers on these "uber-handy" slip on (and weld) flange ends were not originally 3 3/4".
(Posted in: Manifolds to Flowmaster Y)

IMG_0379.JPG
802 hits | 53.08 KB | Posted: 4/27/09
The three philips screws that hold this new (used) piece on are only accessible from underneath.
(Posted in: Minor collision repair)

EPSN0002.JPG
801 hits | 10.1 KB | Posted: 10/17/04
White corner markers now, thanks LEDs
(Posted in: Exterior)

EPSN0002.JPG
801 hits | 47.17 KB | Posted: 12/3/04
spiffy
(Posted in: Exterior)

IMG_0070.JPG
801 hits | 66.24 KB | Posted: 8/6/05
Cover comes off no trouble and allows you plenty of access room from above. There's already plenty of access room from below.
(Posted in: Large Transmission Cooler)

IMG_0021.JPG
801 hits | 74.79 KB | Posted: 2/27/08
My stock connector(which looks identical BTW) was so brittle I just broke my original terminals free of it.
(Posted in: Fuel sending unit harness)

Town Car-6.jpg
800 hits | 38.45 KB | Posted: 8/1/03
(Posted in: 2003 Pics)

10.jpg
797 hits | 56.16 KB | Posted: 12/5/03
Picture 9
(Posted in: 1985 TC)

blktc0004.JPG
797 hits | 74.73 KB | Posted: 6/13/04
(Posted in: Initial)