2009 Crown Vic Crankshaft Position Sensor

Hey guys, glad to be a part of the forum...I have a small taxi company and have a Crown Vic...I can legally drive them here until May 2022 and plan too..

anyways,

I have an 09' p-71 and I have to change the Crankshaft position sensor...I searched and searched the internet and there is nothing for this anywhere, and that's why I am here....

it looks like I have to remove or loosen the AC compressor....

Does anyone know how I do this ?? There are four 10mm bolts on the front of the compressor but they don't seem like they will come off because of the AC pulley.....Do I some how have to remove these bolts ?

Or do I remove those other three nuts kind of on the side ?? They appear to be 13mm on two of those and the third a smaller bolt....

thanks, glad to be a part of the community here....

update....I changed out the crankshaft position sensor and the car is still not starting....It's getting no spark...I may be switching out the PCM...I can get a used one for $75.

i would like to know if the pcm was your problem
having same issues
changed crank sensor and car won't start
also changed alt bat coils and sparkplugs
turns over fine and smells gas after turning 2 or 3 times
feul pump is also new