Nov 10, 2010 at 3:59 AM
Hello All,
I have a suspension subframe from a 2006 Crown Vic police interceptor. The suspension is from a wreck and is being bolted into a much lighter car. I am sure the heavier spring rate and valving in the shocks is going to be too stiff for my application. Is there anyone out there who would like to swap my performance springs and shocks for a set out of a standard Crown Vic? 2003-2007 would work. The set I have is a low mileage (06 front that was wrecked in 0
, so a low mile stock set would be nice.
I am looking to soften the ride a bit and lower the front down. I have seen aftermarket (Eaton) springs, but this is s low budget project and I would rather see what a standard vs P71 swap will do for the front.
I have a suspension subframe from a 2006 Crown Vic police interceptor. The suspension is from a wreck and is being bolted into a much lighter car. I am sure the heavier spring rate and valving in the shocks is going to be too stiff for my application. Is there anyone out there who would like to swap my performance springs and shocks for a set out of a standard Crown Vic? 2003-2007 would work. The set I have is a low mileage (06 front that was wrecked in 0
, so a low mile stock set would be nice.
I am looking to soften the ride a bit and lower the front down. I have seen aftermarket (Eaton) springs, but this is s low budget project and I would rather see what a standard vs P71 swap will do for the front.