SuperMotors.net Forums

Forums > SuperMotors Community Discussion > Engine and Drivetrain

1998 crown vic p74 noise

Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 988

You must be logged in to post in or subscribe to this thread. Pages: 1

WAVE1200 • DIX HILLS, NY, USA • Registered on 5/11/2012 • 5 posts

Posted:5/11/2012 09:04 Hello everyone. I'm new to the forum. I have a 1998 crown vic that has had this noise for a while( maybe 20.000 miles or so and I'm lost . Near the end of the video to make noise go away I stated that i put the car in drive to make it go away, I ment to say i put it in park. Also to bore scope I could not get it all the way up to the flex plate bolts to see any cracks. After I unbolted the flywheel to see if I could see a crack when I bolted the flywheel back up it makes this noise a little louder when the car is first started up in the morning in park and goes away after about 2 minutes. Also sometimes the noise is louder than other times. I have replaced timing guides and i would be upset to remove the transmission to find out the flexplate is good http://www.youtube.com/watch?v=e9taJGnTNRQ&feature=youtu.be edited 5/11/2012 09:18

wizzard1222 • Ballwin, MO, USA • Registered on 1/27/2011 • 139 posts

Posted:5/11/2012 15:45 Sorry to "hear" about your issue.... The inclusion of your video clip was very clean and helpful... Sorry, but I can't be of much help in solving your '"noise"...just not a transmission/flywheel guy.... I'm sure a better answer will come shortly..... Have you just taken it to a Tranny shop for their "Seasoned Knowledge & Experiences"....??? Hope this helps a litttle...

Forums > SuperMotors Community Discussion > Engine and Drivetrain

1998 crown vic p74 noise

Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 988

You must be logged in to post in or subscribe to this thread. Pages: 1