SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Home/ Lincoln/ Town Car/ 1990-1997/ “Mileage Master”/ How-to

How-to

1990 Lincoln Town Car Spark Plug Wire Replacement, Ford Racing 9mm

1990 Lincoln Town Car · Repair · Easy

Documented by SuperMotors from Sixlitre’s photos

The original plug wires on a 1990 Lincoln Town Car were replaced with black 9mm Ford Racing spiral core wires. Sixlitre chose these over the Taylor SpiroPros normally preferred because black SpiroPros were weeks out and a dealer offered a deal on the Ford Racing set.

  1. Step 1

    Select a black wire set to keep the under hood appearance stock. Sixlitre normally prefers Taylor SpiroPros but faced a weeks long wait for black wires, so took a dealer deal on these 9mm Ford Racing wires, which are also described as spiral core.

    Step 1: Select a black wire set to keep the under hood appearance stock. Sixlitre normally prefers Taylor SpiroPros
  2. Step 2

    Remove the weather shield from the distributor cap.

    Step 2: Remove the weather shield from the distributor cap.
  3. Step 3

    With the shield off, inspect the wires underneath. Sixlitre identifies them as the original 15 year old set, citing "1990" marked on the coil wire and non removable heat shielding at several points.

    Step 3: With the shield off, inspect the wires underneath. Sixlitre identifies them as the original 15 year old set
  4. Step 4

    Load both ends of each plug wire with dielectric grease before fitting. Sixlitre does this to stop boots and terminals tearing off on removal and to help conductivity.

    Step 4: Load both ends of each plug wire with dielectric grease before fitting. Sixlitre does this to stop boots and
  5. Step 5

    Route the new 9mm wires, seat each end fully, and keep the wires separated from one another.

    Step 5: Route the new 9mm wires, seat each end fully, and keep the wires separated from one another.
  6. Step 6

    Refit the distributor weather shield to preserve the stock look. Sixlitre notes the MSD coil may still need painting black to complete the effect, though the black plug wires do not draw attention.

    Step 6: Refit the distributor weather shield to preserve the stock look. Sixlitre notes the MSD coil may still need
  7. Step 7

    Check the finished wire runs along the lower side of the engine. Sixlitre is pleased with how well they run. The photos end there.

    Step 7: Check the finished wire runs along the lower side of the engine. Sixlitre is pleased with how well they run.

Some product links go to the supplier the owner bought from. SuperMotors does not earn a commission today; if that changes, this line will say so and creators will be paid from it.