How-to
1990 Lincoln Town Car Cat-Back Exhaust and Muffler Install
A cat-back exhaust swap on a 1990 Lincoln Town Car, replacing the kinked 2 inch Lincoln replacement tailpipe with a mandrel bent 2 1/2 inch Dynomax Impala SS tailpipe and a 2 1/2 inch Hooker Aerochamber muffler. The run is tied together with a bolt-on reducer flange at the cat, a shop-made hanger/clamp, and welded connector and turndown sections.
-
Step 1
Compare the old 2 inch Lincoln replacement tailpipe with the mandrel bent 2 1/2 inch Dynomax Impala SS unit before starting. Sixlitre reports the Impala SS piece is a close to perfect match for the car.
-
Step 2
Unbolt the old connector pipe. Bolt the 3 inch to 2 1/2 inch reducer flange on loosely so it can still be moved.
-
Step 3
Hang the new Dynomax tailpipe loosely over the axle and check the fit of the hanger/clamp. Sixlitre made the hanger/clamp himself, and a helper reshaped it with a torch; pattern a hanger after this revised version rather than the earlier one.
-
Step 4
Use the hanger/clamp to position the 2 1/2 inch Hooker Aerochamber muffler on the stock rubber hangers.
-
Step 5
Bend a short length of 2 1/2 inch pipe and slip it into the Hooker muffler. Sixlitre notes these bends are not mandrel bent, but they were kept flowing and tight to the body.
-
Step 6
Clamp the muffler in and set the tailpipe where it is wanted, then weld the connector pipe to the reducer bolted to the cat. Sixlitre added an Ultra seal gasket and Ultra copper sealant and bolted the joint together with brass nuts and stainless bolts.
-
Step 7
Weld the 3 inch resonator style turndown to a piece of 2 1/2 inch pipe and to the reducer. Sixlitre notes this extra section was needed because the run came up about 8 inches short.
-
Step 8
Set the finished tailpipe and turndown in place on the hanger/clamp. Sixlitre reports a quiet burble at idle and start up, zero drone at cruise, and a strong note under throttle; the photos end with the system installed.
Some product links go to the supplier the owner bought from. SuperMotors does not earn a commission today; if that changes, this line will say so and creators will be paid from it.