L. Please refer to the Trou section in Chapter 7 for dbleshootmg and Installation Tips etails on avoiding installation issues. 2. T ' ' - Cb'fti'rrtStzuijtl? consrsts of mounting the display inside the RV, tanks 9CD: astening the senders to the sides of the holding wirin, Donacging wrring, and programming the display. When cri g T use spade connectors tojoin wires, only use mp on butt connectors or solder the wires together. 3. Mount the display by cutting a hole in the wall 3" wide by 1 7/3" high and bringing the wirin _ 9 out throu h th h l to the display panel connector. 9 e 0 e to COHNGCC 4. Connect the wiring according to the following table. It is easrer to connect the wiring to the display connector first and then plug the connector into the display panel. The senders need to be grounded to a single ground wire from the display Make sure that the system ground is connected to the breaker panel ground. _ -YYEEEEE'" Red 1'8igauge 5. Determine where to mount the senders on the tanks. They will need to have a flat area on the side of the tank large enough so the whole width of the sender is in contact with the side of the tank, all the way from the top to the bottom of the tank. Make sure that any metal is at least an 1 away from either side or the top and bottom of the sender, and at least 2" away from the face of the sender. Clean the area well so that there is no dust, grease, oil, water, etc., that would prevent the adhesive on the sender from sticking. 6. Measure the height of the tank to determine which sender configuration to use and how long the senders should be. Refer to the following table. 5, CAUTION: DO NOT mix sender types when stacking senders. I 70%? 1. Manual FOR SERVICE CONTACT INSTALLING DEALER MADE m CAIADAIFABRIQUE AU CAmm CAN ICES-003(B)INMB-003(El) ' Warning: Cancer and h . Reproductive Harm vwvaSSWarnlngscagou 709-P3- F 053243 I