plastic cover E40d tech.JPG 1191 hits | 53.89 KB | Posted: 2007-07-27 This is the outline of the plastic cover that fell into the transmission oil pan... (Posted in: E40D Valve body cover)
plastic cover E40d.JPG 527 hits | 48.22 KB | Posted: 2007-07-27 E40D Plastic Vavle body cover with out it my Bronco was not shifting correctly and it would stall the motor in reverse.... (Posted in: E40D Valve body cover)
DSC04053.JPG 1391 hits | 46.33 KB | Posted: 2007-07-24 Purchased the clips Part number #K066 from
www.Transmissioncenter.net speak with [email protected] I got the part in two days Great Service!!
DSC04051.JPG 1224 hits | 52.98 KB | Posted: 2007-07-24 Filter clip installed, The one bolt down from the dip stick area. ... (Posted in: E40D Filter clip installation)
DSC03828.JPG 441 hits | 62.74 KB | Posted: 2007-07-24 Converter was stuck to the motor could not turn the motor since I bent the rod #8... (Posted in: Bronco tear down pics)
DSC03824.JPG 395 hits | 77.12 KB | Posted: 2007-07-24 Motor is out of the Bronco.... (Posted in: Bronco tear down pics)
DSC03813.JPG 420 hits | 73.48 KB | Posted: 2007-07-24 what a mess of wires and lines, Had the enjector cleaned and evaulated by RC Engineering In Torrance CA. Those guys are super cool and got the job done in a day!! Two injectors where dripping will post results later on ejector duty cycle and spray pattern.... (Posted in: Bronco tear down pics)
DSC03794.JPG 313 hits | 65.08 KB | Posted: 2007-07-24 Belt travel, that belt needs to be replaced... (Posted in: Bronco tear down pics)
DSC03792.JPG 325 hits | 66.68 KB | Posted: 2007-07-24 Bronco Motor still in place getting ready to remove... (Posted in: Bronco tear down pics)
DSC03042.JPG 347 hits | 58.63 KB | Posted: 2007-07-24 1995 Ford Bronco on 35's Procomp Xterrain tires with a 6 inch Pro Comp lift. The cobination works great!... (Posted in: Bronco pics)
DSC03017.JPG 345 hits | 69.54 KB | Posted: 2007-07-24 Transfer case motor assembly.... (Posted in: Bronco pics)
DSC02985.JPG 306 hits | 63.55 KB | Posted: 2007-07-24 The transfer case would not engage so I took apart the transfer case stepper motor driver board. cleaned it up and re-solder the connection and everything works great now. ... (Posted in: Bronco pics)
DSC02990.JPG 309 hits | 60.98 KB | Posted: 2007-07-24 Optima battery upgrade made the cable after I was told it would cost me $75 per cable. I went down to the local electronic store and got all the cable and fitting for about $40. ... (Posted in: Bronco pics)
