000_0106.jpg 327 hits | 54.19 KB | Posted: 2007-05-29 this is the back of the gauges where they are monted to the black plexy glass, you can see how i epoxied it to the original gauge bezel...i had to trim the original bezel so that the gauges would stand up straight. there is a small indention about a 1/2 inch back from the front edge that i followed in order to keep it straight....all of these parts came from a junkyard (except for the autometer gauges) i kept all of my original parts to reinstall if i need to... (Posted in: bronco gauge cluster)
000_0104.jpg 382 hits | 60.29 KB | Posted: 2007-05-29 this is the circuit board where i traced all of my wiring ....you need to keep this so your blinkers,check engine light ,brake,anti lock and 4x4 lights will still work... (Posted in: bronco gauge cluster)
000_0103.jpg 386 hits | 59.74 KB | Posted: 2007-05-29 here you can see where i spliced into the wiring... (Posted in: bronco gauge cluster)
000_0102.jpg 294 hits | 47.39 KB | Posted: 2007-05-29 here you can see where i had to modify (cut) for the speedometer cable. i had to order a costom speedo cable from a link i found at the autometer website... also you can see the wire for fuel sending unit...... (Posted in: bronco gauge cluster)
000_0101.jpg 324 hits | 31.73 KB | Posted: 2007-05-29 here is the wire that sends the signal to the tach... (Posted in: bronco gauge cluster)
